In this paper, we raise a question about existence of secure password-based authenticated key exchange against leakage of internal states (i.e., the passwords and session-specific private information). Toward this question, first, we classify six models of adversary's capabilities about leakage. Next, as a result of considerations for 2-party PAKE, we find two negative answers, but also find a positive answer. More specifically, we show that there exists no scheme which is secure in strong leakage models, but we also show that there exists a scheme which is secure in weak leakage models. Also, we consider the case of 3-party setting which is a special setting of password-based authenticated key exchange, and we find similar impossibilities as 2-party setting.

In this paper, we investigate the transitional dynamics and quasi-periodic solution appearing after the Saddle-Node (SN) bifurcation of a periodic solution in an inductor-coupled asymmetrical van der Pol oscillators with hard-type nonlinearity. In particular, we elucidate, by investigating global bifurcation of unstable manifold (UM) of saddles, that transitional dynamics and quasi-periodic solution after the SN bifurcation appear based on different structure of UM.

Minimizing the residual impurity gases is a key factor for reducing temporal dark image sticking. Therefore, this paper uses a vacuum-sealing method that minimizes the residual impurity gases by enhancing the base vacuum level, and the resultant change in temporal dark image sticking is then examined in comparison to that with the conventional sealing method using 42-in. ac-PDPs with a high Xe (11%) content. As a result of monitoring the difference in the display luminance, infrared emission, and perceived luminance between the cells with and without temporal dark image sticking, the vacuum-sealing method is demonstrated to reduce temporal dark image sticking by decreasing the residual impurity gases and increasing the oxygen vacancy in the MgO layer. Furthermore, the use of a modified driving waveform along with the vacuum-sealing method is even more effective in reducing temporal dark image sticking.

We propose Adaptive Resource Allocation for the Partial Block MC-CDMA (ARA-PB/MC-CDMA) system. The ARA-PB/MC-CDMA system aims to improve total throughput performance and frequency efficiency across various channel conditions. It adaptively changes the number of blocks to improve the throughput performance and frequency efficiency according to the Signal to Interference Ratio (SIR). Therefore, the proposed system supports various Quality of Service (QoS) requirements for various SIR values.

In this paper, active frequency selective surfaces (FSS) having a squared aperture with a metal plate loading are described. Active FSS elements using switched PIN diodes are discussed with an equivalent circuit model. A unit cell consists of a square aperture element with metal island loading and one PIN diode placed at the upper gap, considering the vertical polarization. The electromagnetic properties of the active FSS structure are changed by applying dc bias to the substrate, and they can be estimated by the equivalent circuit model of the FSS structure and PIN diode. This active FSS design enables transmission to be switched on or off at 2.3 GHz, providing high transmission when the diodes are in an off state and high isolation when the diodes are on. The equivalent circuit model in the structure is investigated by analyzing transmission and reflection spectra. Measurements on active FSS are compared with numerical calculations. The experimentally observed frequency responses are also scrutinized.

Mobile Ad Hoc Networks (MANETs) are temporal and infrastructure-independent wireless networks that consist of mobile nodes. For instance, a MANET can be used as an emergent network for communication among people when a disaster occurred. Since there is no central server in the network, each node has to find out its desired information (objects) by itself. Constructing a mobile Peer-to-Peer (P2P) network over the MANET can support the object search. Some researchers proposed construction schemes of mobile P2P networks, such as Ekta and MADPastry. They integrated DHT-based application-layer routing and network-layer routing to increase search efficiency. Furthermore, MADPastry proposed a clustering method which groups the overlay nodes according to their physical distance. However, it has also been pointed out that the search efficiency deteriorates in highly dynamic environments where nodes quickly move around. In this paper, we focus on route disappearances in the network layer which cause the deterioration of search efficiency. We describe the detail of this problem and evaluate quantitatively it through simulation experiments. We extend MADPastry by introducing a method sharing objects among nodes in a cluster. Through simulation experiments, we show that the proposed method can achieve up to 2.5 times larger success rate of object search than MADPastry.

Nucleic acid sensor based on polyaniline has been fabricated by covalently immobilizing double stranded calf thymus (dsCT) DNA onto perchlorate (ClO- 4) doped polyaniline (PANI) film deposited onto indium-tin-oxide (ITO) glass plate using 1-(3-(dimethylamino) propyl)-3-ethylcarbodiimide hydrochloride (EDC)/N-hydroxyl succinimide (NHS) chemistry. These dsCT-DNA-PANI/ITO and PANI/ITO electrodes have been characterized using square wave voltammetry, electrochemical impedance, and Fourier-transform-infra-red (FTIR) measurements. This disposable dsCT-DNA-PANI/ITO bioelectrode is stable for about four months, can be used to detect arsenic trioxide (0.1 ppm) in 30 s.

This work proposes new features to improve the pathological voice quality classification performance. They are the means, the variances, and the perturbations of the higher-order statistics (HOS) such as the skewness and the kurtosis. The HOS-based features show meaningful differences among normal, grade 1, grade 2, and grade 3 voices classified in the GRBAS scale. The jitter, the shimmer, the harmonic-to-noise ratio (HNR), and the variance of the short-time energy are utilized as the conventional features. The performances are measured by the classification and regression tree (CART) method. Specifically, the CART-based method by utilizing both the conventional features and the HOS-based ones shows its effectiveness in the pathological voice quality measurement, with the classification accuracy of 87.8%.

We have developed novel humidity and gas detector system using quartz crystal oscillators (QCO) deposited with cellulose Langmuir-Blodgett (LB) films. We have realized stable humidity detection by the LB-based QCO sensor for extremely high humidity subsequent to the water dipping condition. Also, specific gaseous molecules such as alcohol could have been sensitively detected.

We have developed an amperometric sensor employing a photoconductive organic thin film that enables the measurement of the two-dimensional distribution of redox current on a sensor surface. The sensor simply consists of photoconductive film and transparent electrode. A focused light beam through the transparent electrode excites the photoconductive film that leads to detect local redox current at the beam position. Intensity of the redox current depends on local concentration of redox species of solution on the sensor. We investigated several materials for the photoconductive film and found a suitable structure is Cu-phthalocyanine doped polyvinylcarbazole film/indium tin oxide/glass substrate. Compared with a conventional two-dimensional chemical sensor, our newly developed sensor can be prepared by lower cost fabrication methods without complex semiconductor processes. The sensor showed a good signal dependence on the concentration of K3Fe(CN)6/K4Fe(CN)6 in an aqueous solution at 15.4 nA/dec at a constant bias voltage of 0.8 V. We measured the two-dimensional distribution of ions in an agarose gel of 2 mm thickness. The result showed a photograph of the diffusion process of redox species. We also discuss the discrimination of redox species like voltammetry.

One-dimensional photonic crystal (PC) with alternating layers of TiO2 and SiO2 was fabricated with spin coating and low temperature baking, resulting in a successful tuning of the PC stop band so as to block the amplified spontaneous emission (ASE) of a π-conjugate polymer film. Single PC as a substrate, not a cavity with two PC's, of the polymer film was sufficient to shift the tangential ASE to the energy at PC stop band edge, indicating that the tangential ASE propagating along the interface was modulated by its evanescent-field tail in the PC, which opens the new pathway for low-threshold coherent luminescence from an ultrathin π-conjugate polymer film with ultimate mode volume.

The electrostatic force required for the driving of liquid droplet injected in a microchannel was studied to obtain the guiding principle to reduce the driving voltage of waveguide optical switch based on the movement of droplet. We analytically calculated the relation between the threshold voltage and velocity of droplet and the surface roughness of microchannel, and clarified some unconfirmed parameters by comparing experimental results and aeromechanical analysis. The driving of droplet in a microchannel was best analyzed using the Hagen-Poiseuille flow theory, taking into account the movement of both ends of the droplet. When the droplet is driven by some external force, a threshold of the external force occurs in the starting of movement, and hysteresis occurs in the contact angle of the droplet to the side wall of the microchannel. The hysteresis of contact angle is caused by the roughness of side wall. In our experiment, the threshold voltage ranged from 200 to 350 V and the switching time from 34 to 36 ms. The velocity of droplet was evaluated to be 0.3-0.4 mm/s from these experimental results. On the other hand, the measured angle distribution of side wall roughness ranged from 30 to 110 degrees, and the threshold voltage was evaluated to be 100-320 V, showing a good agreement with experimental results. The reduction of threshold voltage can be realized by smoothing the side wall roughness of microchannel. The switching time of 10 ms, which is required for the optical stream switch, can be obtained by shortening the horizontal spot size down to 1.5 µm.

The bioelectric potential of plants is generated by ion concentration difference between inside and outside of plant cells. It has been reported that the bioelectric potential of leaves changes at the beginning of steady irradiation and intensity of the potential response increases with the photosynthetic rate. Although it has been reported that photosynthesis is accelerated by blinking irradiation, the potential response under the blinking irradiation have not been fully clarified. In this study, we measured the bioelectric potential and CO2 consumption of plants under various types of the blinking irradiation. This result showed that the potential response under the blinking irradiation has various behaviors and intensity of the response related to photosynthetic rate. We conclude that our method is suitable for monitoring the biological activity of plants such as photosynthesis.

With the popularity of BitTorrent-like P2P applications, improving its performance has been an active research area. Super-seeding, a special upload policy for the initial seeder, improves the efficiency in producing multiple seeds and reduces the uploading bytes of content initiators, thus being highly expected as a promising solution for improving downloading performance while decreasing uploading cost. However, the overall impacts of super seeding upon BitTorrent performance remain a question and have not been analyzed so far in literature. In this paper, we present an analytical and experimental study over the performance of super-seeding scheme. We attempt to answer the following questions: whether and how much super-seeding saves uploading cost, whether the overall downloading time is decreased by super-seeding, and in which circumstances super-seeding performs worse. Based on the seeding process, our analytical study gives formulas on the new piece distribution time, average downloading time and minimum distribution time for heterogeneous P2P file distribution system with super-seeding. Robust evidence supporting the use (or not) of super-seeding is given based on our worldwide Internet experiments over wide distribution of 250 PlanetLab nodes. With a well-designed experimental scenario, we study the overall download time and upload cost of super seeding scheme under varying seed bandwidth and peer behavior. Results show that super-seeding can save an upload ratio of 20% and does help speeding up swarms in certain modes. Tentative conclusions about the effectiveness of super-seeding and its optimal working circumstances are given with inside mechanism analyzed and negative factor identified. Our work not only provides reference for the potential adoption of super-seeding in BitTorrent and other P2P applications, but also much insights for the tussle of enhancing of Quality of Experience (QoE) and saving cost for a large-scale BitTorrent-like P2P commercial application.

In this paper, we propose an Adaptive Stochastic Collocation Method for block-based Statistical Static Timing Analysis (SSTA). A novel adaptive method is proposed to perform SSTA with delays of gates and interconnects modeled by quadratic polynomials based on Homogeneous Chaos expansion. In order to approximate the key atomic operator MAX in the full random space during timing analysis, the proposed method adaptively chooses the optimal algorithm from a set of stochastic collocation methods by considering different input conditions. Compared with the existing stochastic collocation methods, including the one using dimension reduction technique and the one using Sparse Grid technique, the proposed method has 10x improvements in the accuracy while using the same order of computation time. The proposed algorithm also shows great improvement in accuracy compared with a moment matching method. Compared with the 10,000 Monte Carlo simulations on ISCAS85 benchmark circuits, the results of the proposed method show less than 1% error in the mean and variance, and nearly 100x speeds up.

Threshold Inverter Quantization (TIQ) technique has been gaining its importance in high speed flash A/D converters due to its fast data conversion speed. It eliminates the need of resistor ladders for reference voltages generation which requires substantial power consumption. The key to TIQ comparators design is to generate 2n - 1 different sized TIQ comparators for an n-bit A/D converter. This paper presents a highly efficient TIQ comparator design methodology based on an analytical model as well as SPICE simulation experimental model. One can find any sets of TIQ comparators efficiently using the proposed method. A 6-bit TIQ A/D converter has been designed in a 0.18 µm standard CMOS technology using the proposed method, and compared to the previous measured results in order to verify the proposed methodology.

Recently, a data-selective method has been proposed to achieve low misalignment in affine projection algorithm (APA) by keeping the condition number of an input data matrix small. We present an improved method, and a complexity reduction algorithm for the APA with the data-selective method. Experimental results show that the proposed algorithm has lower misalignment and a lower condition number for an input data matrix than both the conventional APA and the APA with the previous data-selective method.

To evaluate frequency-domain interference between orthogonally intersecting stripline geometries, a lumped mutual capacitance was incorporated into a circuit model, and then a simplified circuit was proposed in the previous paper. The circuit model was approximated from an investigation of the distribution of mutual capacitance but it has remained how the capacitance is approximated. In this paper, a technique using an error function is proposed for the problem. Then, the time-domain response in an analytical expression is studied using the simplified circuit model in a Laplace transformation to make the mechanism clear. Comparing the experimental and the computed results verifies the proposed models.

In a multi-user orthogonal frequency division multiplexing (OFDM) system, efficient resource allocation is required to provide service to more users. In this letter, we propose an improved subcarrier allocation algorithm that can increase the spectral efficiency and the number of total transmission bits even if the number of users is too large. The proposed algorithm is divided into two stages. In the first stage, a group of users who are eligible for services is determined by using the bit error rate (BER), the users' minimum data rate requirement, and channel information. In the second stage, subcarriers are first allocated to the users on the basis of channel state, and then the reallocation is performed so that resource waste is minimized. We show that the proposed algorithm outperforms the conventional one on the basis of outage probability, spectral efficiency, and the number of total transmission bits through a computer simulation.

Time-resolved microscopic optical second harmonic generation (TRM-SHG) imaging measurement revealed quantitatively the potential drop at the electrode contact of pentacene field effect transistors (FET). An activation of the SH signal at the edge of Ag-source electrode indicates the presence of large potential drop at pentacene-Ag contact during device operation, whereas negligible potential drop was observed at pentacene-Au contact. These findings agree with the injection characteristics of electrodes owing to the relationship between the work function of the metal and the HOMO level of pentacene.