Binary and ternary 5-bit programmable dispersion matrix, based on fiber Bragg reflectors, is built to control a two-channel receive/transmit beamformer at 1550 nm. RF phase measurements for the 32/31 delay configurations are presented. The programmable dispersion matrix is fully demonstrated and characterized for RF signals from 0.2 to 1 GHz.

In this paper, the authors intend to propose a new untraceable blind signature scheme based on the RSA cryptosystem. This paper applies the Extended Euclidean algorithm to our blind signature scheme. Compared with other blind signature schemes, our proposed scheme can meet the all requirements of a blind signature scheme. The security of the proposed scheme, as did that of the RSA cryptosystem, depends on the difficulty of solving the factoring problem.

The dense wavelength division multiplexing (DWDM) technique is very attractive for effectively increasing the channel capability, even for access networks. Some DWDM radio-on-fiber (ROF) systems have been studied recently. In those systems, fiber Bragg gratings (FBG) or arrayed waveguide gratings (AWG) were used to demultiplex DWDM ROF signals. In this report, an alternative channel-selection scheme of DWDM millimeter-wave-band ROF signals by optical heterodyne detection with dual-mode local light is newly proposed. Error-free demultiplexing and transmission over a 25-km-long SMF of the DWDM signal, which consists of two 60-GHz-band, 155-Mb/s-DPSK ROF signals, are demonstrated.

Recent advances of Web information systems such as e-commerce and e-learning have created very large but hidden demands on conceptual multiresolution analysis for more generalized information analysis, cognition and modeling. To meet the demands in a general way, its modeling is formulated based on modern algebraic topology. To be specific, the modeling formulation is worked out in an incrementally modular abstraction hierarchy with emphasis on the two levels of the hierarchy appropriate for conceptual modeling: the adjunction space level and the cellular structured space level. Examples are shown to demonstrate the usefulness of the presented model as well as an implementation of a flower structure case.

A novel interference reduction method, transmit power and window control (TPWC), is proposed to enhance the system capacity in the downlink of code division multiple access (CDMA) cellular packet systems. TPWC measures the propagation conditions and calculates the required instantaneous transmit power between a base station (BS) and a mobile station (MS). Then, TPWC sends packets only during a transmit time-window, in which the packets can be sent with less power than a predetermined threshold. TPWC reduces the average transmit power at the cost of an extra transmission delay at the BS. Computer simulations show that TPWC enhances the system capacity by two-fold in a CDMA cellular packet system when each MS has a loading ratio of 0.5 and an average delay allowance of 5 ms for the unit packet length of 1 ms. Furthermore, this paper proposes a multi-link packet transmission (MLPT) scheme in order to reduce the delay caused by TPWC. When an MS is at the cell edge, packets are distributed by MLPT to multiple BSs, from which packets are sent to the MS; thus, the transmission delay can be reduced by utilizing the transmit windows of each BS.

In recent years, sliding electric contacts came to be often used under very severe conditions such as high temperature, extremely low temperature, high vacuum, etc. Conventionally, solid lubricants having excellent properties in lubricating performance are generally used compositely with a metal of high electric conductivity, because of their high electrical resistivity. In the present study, we proved that more excellent sliding electrical contacts can be produced with a design made by controlling the distribution on contact surface of a solid lubricant having excellent lubricating performance and of a metal with high electric conductivity through expansion of Greenwood's theory.

This paper describes two methods to construct fuzzy inference rules by the simplified fuzzy reasoning. The present methods have a construction mechanism of the rule unit that is applicable in two parameters: the central value and the width of the membership function in the antecedent part. The first approach is to create a rule unit near the selected rule which has the nearest position from the central input space for the central value. The second is to create a rule unit near the selected rule which has the minimum width for the width. Experimental results are presented in order to show that the proposed methods are effective in difference on the inference error and the number of learning iterations.

In order to establish rapid diagnosing in TDX signaling service, it has developed a PCM signal acquisition (PCMA) system which can analyze status of signals sent from/received to a signaling equipment, providing the fully electronic switching system. The system has a function of acquirement PCM signal of the preferred channel from the subhighway (SHW), connecting a universal signal transceiver unit (USTU) and time switch unit (TSU), and then it classifies the type of signal such as R2MFC/DTMF/CCT/VOICE, and finally discriminates the digit. This paper analyze the signal status of the PCMA system using the quick Fourier transform (QFT) based the symmetric properties, and discusses the algorithm of signal analysis and discrimination. In the experimental results, it shows the improved performance to the PCMA and reduce memory waste and process the real-time.

This paper presents a review of volumetric erosion studies applied to electrical contacts. The numerical methods presented are generic and could equally be applied to a number of areas where surfaces have been eroded or damaged. Equally there is no scale limitation of the surfaces to which the numerical methods can be applied. The paper starts with an introduction of the issues associated with the measurement of contact erosion, and then presents a summary of various hardware system for making 3D measurements of surfaces such as electrical contacts. This is followed by a review of the generic form fitting methods and also volume calculation methods. The paper concludes with a review of results taken from a test system for contact studies and from contact samples taken from commercial relays.

The effect of the silicone vapor on the reliability of the micro-motor was examined. Adsorbed silicone was decomposed to SiO2 by heating due to the discharge between brush and commutator surface. It was found that the operation time until the failure was extremely shortened by the formation of SiO2. The existence of the maximum operation time until the failure was found as depending on the number of revolution. For the higher revolution, many amounts of SiO2 accumulated by the decomposition of the silicone shorten the operation time. For lower revolution, as the torque of the motor reduces, the operation time also shortens. Therefore, the maximum operation time exists for optimum revolution.

In this paper, to enhance the power efficiency a new simple space-time coding scheme is devised with application to the OFDM based Wireless LAN system. The basic idea is from the receiver's point of view and is referred to as Virtual Constellation Mapping (VCM). We designed a new combination of the channel coding (Turbo Code) along with multiple transmit antennas (Two antennas) to achieve transmit diversity and space division multiplexing transmission. Computer simulation results showed that with the same transmission data rate, our proposed scheme can achieve better bit error rate (BER) compared with the conventional space-time trellis coded OFDM scheme in high Doppler fading channels.

An efficient performance enhancement scheme using the rotation of signal subspace (RSS) and Toeplitz matrix approximation (TMA) methods to enhance the performance of an adaptive antenna array in DS/CDMA systems is proposed. The basis of RSS is to find a transformation matrix in order to recover the desired complex array covariance matrix from a sampled complex array covariance matrix which is contaminated by an interference-plus-noise component. Also, the objective of TMA is to change the output matrix of RSS into a matrix having the theoretical properties such as Toeplitz structure matrix or a positive semidefinite matrix. Consequently, the proposed scheme using RSS and TMA methods can greatly improve the performance of an adaptive antenna array by reducing the interference-plus-noise effect from the sampled complex array covariance matrix of the pre-correlation received signal vector that is used to calculate a weight vector of an adaptive antenna array. Simulation results demonstrate the effectiveness of the proposed scheme.

A field trial, within a suburban macro-cell environment, of a space-time (ST) equalizer for TDMA mobile communication systems is described. The ST equalizer was a cascade connection of two array processors for a four-antenna array and a two-branch-metric-combining maximum-likelihood sequence estimation (MLSE) that was designed to obtain full space- and path-diversity gains from first-arrival and one-symbol-delayed signals while suppressing excessively long-delayed inter-symbol interference (ISI). The radio frequency was 3.35 GHz, the transmission rate was 4.096 Mb/s, and the modulation was QPSK. The long-delayed ISI reduction and the space-path diversity effect of the ST equalizer was validated by Eb/N0 vs. bit-error-rate (BER) curves with respect to delay spread and antenna spacing as compared with the case of an array processor alone being used.

Gallium nitride (GaN) is one of the wurtzite-type materials and has semiconducting properties. Crystallinities of GaN thin films are usually poor when they are directly grown on polycrystalline metal-foils which are expected as substrates for realizing novel giant microelectronic devices. Improvements of crystal orientations of GaN thin films grown on such polycrystalline metal-foils are tried by using several kinds of intermediate layers. Aluminum nitride (AlN), GaN, silicon dioxide (SiO2) and Si are chosen as materials for the intermediate layers. The crystal orientations of GaN thin films grown by inserting the SiO2 and Si intermediate layers with adequate thicknesses are markedly improved, while those grown on the AlN or GaN intermediate layers are not improved. These differences are not caused by the kinds of the materials used for the intermediate layers but by differences in their crystallinities.

This paper proposes a new signal peak power reduction technique, Peak Reduction based on Control Signal Insertion (PRCSI), for broadband mobile communications based on multi-channel signaling schemes. PRCSI reduces the peak power with a peak control signal that is generated symbol-by-symbol; no signal band expansion is incurred because the peak control signal is inserted into the transmission signal band. PRCSI can achieve 4 dB peak power reduction for 8-carrier signaling, while the Eb/N0 value required to achieve 10-3 average BER is 1 dB larger with PRCSI than without it. This BER performance degradation can effectively be compensated by the proper use of Trellis coding. The proposed technique is applied to OFDM transmission systems with large carrier number. The proposed technique can achieve 3-dB peak power ratio for 128-carrier OFDM signals with less than 1-dB performance degradation at the BER of 10-3.

We describe a low-cost and extremely stable millimeter-wave transmission system that uses a double-side-band (DSB) millimeter-wave self-heterodyne transmission technique. This technique allows us to use a comparatively low-cost and unstable millimeter-wave oscillator regardless of the modulation format. Furthermore, a transmission band-pass-filter (BPF) is not needed in the millimeter-wave band. The system cost can therefore be substantially reduced. We have theoretically and experimentally evaluated the carrier-to-noise power ratio (CNR) performance that can be obtained when using this technique relative to that attainable through a conventional millimeter-wave self-heterodyne technique where a single-side-band signal is transmitted. Our results show that the DSB self-heterodyne transmission technique can improve CNR by more than 3 dB.

It is well known that Orthogonal Frequency Division Multiplexing (OFDM) scheme is robust to frequency selective fading in wireless channels. However, once delayed signals beyond a guard interval of an OFDM symbol are introduced in a channel with large delay spread, inter-symbol interference causes a severe degradation in the transmission performance. In this paper, we propose a novel pre-Fast Fourier Transform (FFT) OFDM adaptive antenna array, which requires only one FFT processor at a receiver, for suppressing such delayed signals. We analytically derive the optimum weights for the beamformer based on the Maximum Signal-to-Noise-and-Interference power Ratio (SNIR) and the Minimum Mean Square Error (MMSE) criteria, respectively. Computer simulation results show its good performance even in a channel where Directions of Arrival (DoAs) of arriving waves are randomly determined.

Utilizing a macromodel which calculates the floating gate potential by combining resistances and dependent voltage and current sources, DC transfer characteristics for multi-input neuron MOS inverters and for those in the neuron MOS full adder circuit are simulated both at room temperature and at 77 K. Based on the simulated results, low temperature circuit failures are discussed. Furthermore, circuit design parameter optimization both for low and room temperature operations is described.

The performance of radio frequency integrated circuits (RFICs) in silicon-on-insulator (SOI) technology can be improved by using a high-resistivity SOI substrate. We investigated the correlation between substrate resistivity and the performance of a low noise amplifier (LNA) on ELTRAN(R) SOI-Epi wafersTM, whose resistivity can be controlled precisely. The use of high-resistivity ELTRAN wafers improves the Q-factor of spiral inductors, and thereby increases the gain and narrows the bandwidth of the LNA. Using the high-resistivity ELTRAN wafers, we have successfully fabricated a 2.4-GHz and 5-GHz CMOS LNA in 0.35-µm SOI CMOS technology, whose process cost is lower than the latest CMOS technologies.

This Letter proposes a timer based ordered registration (TBOR) scheme for CDMA private user zone (PUZ) service. The proposed TBOR scheme solves the problem that both the PUZ system loads and the public system loads are increased due to excessive registration. Also the TBOR scheme is quite simple to implement and compatible with the existing public CDMA system.