The transfer distance of the wireless power transfer (WPT) system with relay coil is longer, so this technology have a better practical perspective. But the location of the relay coil has a great impact on the transmission efficiency of the WPT system, and it is not easy to analyze. In order to research the influence law of the relay coil location on the transmission efficiency and obtain the optimal location, the paper firstly proposes the concept of relay coil location factor. And based on the location factor, a novel method for studying the influence of the relay coil location on the transmission efficiency is proposed. First, the mathematical model between the transmission efficiency and the location factor is built. Next, considering the transfer distance, coil radius, coil turns and load resistance, a lot of simulations are carried out to analyze the influence of the location factor on the transmission efficiency, respectively. The influence law and the optimal location factor were obtained with different parameters. Finally, a WPT system with relay coil was built for experiments. And the experiment results verify that the theoretical analysis is correct and the proposed method can simplify the analysis progress of the influence of relay coil location on the transmission efficiency. Moreover, the proposed method and the research conclusions can provide guidance for designing the multiple coils structure WPT system.

To realize a stable and efficient wireless power transfer (WPT) system that can be used in any environment, it is necessary to inspect the influence of environmental interference along the power transmission path of the WPT system. In this paper, attempts have been made to reduce the influence of the medium with a dielectric and conductive loss on the WPT system using spiral resonators for resonator-coupled type wireless power transfer (RC-WPT) system. An important element of the RC-WPT system is the resonators because they improve resonant characteristics by changing the shape or combination of spiral resonators to confine the electric field that mainly causes electrical loss in the system as much as possible inside the resonator. We proposed a novel dual-spiral resonator as a candidate and compared the basic characteristics of the RC-WPT system with conventional single-spiral and dual-spiral resonators. The parametric values of the spiral resonators, such as the quality factors and the coupling coefficients between resonators with and without a lossy medium in the power transmission path, were examined. For the lossy mediums, pure water or tap water filled with acryl bases was used. The maximum transmission efficiency of the RC-WPT system was then observed by tuning the matching condition of the system. Following that, the transmission efficiency of the system with and without lossy medium was investigated. These inspections revealed that the performance of the RC-WPT system with the lossy medium using the modified shape spiral resonator, which is the dual-spiral resonator proposed in our laboratory, outperformed the system using the conventional single-spiral resonator.

In IEEE 802.11 wireless local area networks (WLANs), contention window (CW) in carrier sense multiple access with collision avoidance (CSMA/CA) is one of the most important techniques determining throughput performance. In this paper, we propose a novel CW control scheme to achieve high transmission efficiency in dense user environments. Whereas the standard CSMA/CA mechanism. Employs an adaptive CW control scheme that responds to the number of retransmissions, the proposed scheme uses the optimum CW size, which is shown to be a function of the number of terminal stations. In the proposed scheme, the number of terminal stations are estimated from the probability of packet collision measured at an access point (AP). The optimum CW size is then derived from a theoretical analysis based on a Markov chain model. We evaluate the performance of the proposed scheme with simulation experiments and show that it significantly improves the throughput performance.

Multiple-input multiple-output (MIMO) transmission is attracting interest for increasing the transmission rates of wireless systems. This paper surveys MIMO transmission technology from the viewpoints of transmission methods, access control schemes, and total transmission efficiency. We consider wireless local area networks (WLAN) systems that use MIMO technology; moreover, we focus on multiuser MIMO (MU-MIMO) technology, which will be introduced in next-generation WLAN systems such as IEEE802.11ac. This paper explains the differences in the detailed access control procedures for MIMO and MU-MIMO transmission, including channel state information (CSI) acquisition. Furthermore, the issues related to CSI feedback and solutions are also discussed. Related works on the medium access control (MAC) protocol in MIMO/MU-MIMO transmission are introduced. In addition, the throughput performance using MIMO/MU-MIMO transmission is evaluated considering an IEEE802.11ac-based WLAN system. From the numerical evaluation, it is shown that the overhead due to CSI feedback from the user terminals to the base station causes a decrease in the throughput. We verified that implicit beamforming, which eliminates CSI feedback, is effective for solving this issue.

Recently, a promising packet forwarding architecture COPE was proposed to essentially improve the throughput of multihop wireless networks, where each network node can intelligently encode multiple packets together and forward them in a single transmission. However, COPE is still in its infancy and has the following limitations: (1) COPE adopts the FIFO packet scheduling and thus does not provide different priorities for different types of packets. (2) COPE simply classifies all packets destined to the same nexthop into small-size or large-size virtual queues and examines only the head packet of each virtual queue to find coding solutions. Such a queueing structure will lose some potential coding opportunities, because among packets destined to the same nexthop at most two packets (the head packets of small-size and large-size queues) will be examined in the coding process, regardless of the number of flows. (3) The coding algorithm adopted in COPE is fast but cannot always find good solutions. In order to address the above limitations, in this paper we first present a new queueing structure for COPE, which can provide more potential coding opportunities, and then propose a new packet scheduling algorithm for this queueing structure to assign different priorities to different types of packets. Finally, we propose an efficient coding algorithm to find appropriate packets for coding. Simulation results demonstrate that this new COPE architecture can further greatly improve the node transmission efficiency.

This paper presents a wireless burst modulation/ demodulation method for narrowband ubiquitous communication systems. This method especially suits those systems, whose traffic is especially dominated by short frame bursts. The proposed modulation method provides a preamble-less frame structure with training symbols, which improves both transmission efficiency and burst synchronization performance. Moreover, the proposed demodulation method achieves superior burst synchronization performance in low carrier-to-noise power ratio (CNR) environments by applying a synchronization method that includes symbol timing recovery, slot synchronization, carrier frequency correction and channel tracking. In addition, this paper presents the result of experiments on hardware prototypes of the proposed modulator and demodulator. The basic operation and practical performance of the proposed method is confirmed through testbed studies.

In this paper, to investigate the processing requirements at each node and offered network load of receiver-based and router-based protocols, we analyze the number of packet transmissions on each link until all receivers receive a packet for an arbitrary multicast-tree topology and packet loss probability considering the correlation between loss events of a packet for different receivers. In order to show the effectiveness of the analytical results, we demonstrate the numerical examples for various conditions. The numerical results show that local recovery protocols, especially router-based protocol can reduce the offered network load due to data packets and their acknowledgements, and can decentralize processing requirement of sending nodes effectively. Further, we reveal the influence of the locations of group senders on the performance of both protocols.

In this paper, we discuss power spectrum overlapping of wideband/narrowband signals and wideband/wideband signals for increasing transmission efficiency. Here, in order to eliminate cross signal interference among those signals, we propose a generalized zero-forcing type decorrelating detection. Our numerical results show that, with the decorrelating detector, the overlapped wideband/wideband signal transmission can much improve the transmission efficiency. This implies that, for a given frequency bandwidth, in order to increase the information transmission rate, we should employ two different kinds of direct sequence spread spectrum-based signals with each power spectrum appropriately overlapped, not taking a single carrier-based approach nor an orthogonal multi-carrier approach.

A model for time spread-pulse position modulation (TS-PPM)/code division multiple access (CDMA) systems is presented. A TS signal is produced by a TS-filter, whose characteristic is a pseudonoise sequence in frequency domain. The error probability performance is analyzed and compared with those of on-off keying (OOK) and binary phase shift keying (BPSK). It is shown that at the same transmission speed TS-PPM is superior to TS-OOK and TS-BPSK due to the dramatic decrease of multiple access interference. The throughput of the network is analyzed, and its relation to the length of pseudonoise sequence and the packet length is also discussed.