This paper presents the dual-band bandpass filters (BPFs) design composed of λ/2 and symmetrically/asymmetrically paired λ/4 stepped impedance resonators (SIRs) for the WLAN applications. The filters cover both the operating frequencies of 2.45 and 5.2 GHz. The dual-coupling mechanism is used in the filter design to provide alternative routes for signals of selected frequencies. A prototype filter is composed of λ/2 and symmetrical λ/4 SIRs. The enhanced wide-stopband filter is then developed from the filter with the symmetrical λ/4 SIRs replaced by the asymmetrical ones. The asymmetrical λ/4 SIRs have their higher resonances frequencies isolated from the adjacent I/O SIRs and extend the enhanced filter an upper stopband limit beyond ten time the fundamental frequency. Also, the filter might possess a cross-coupling structure which introduces transmission zeros by the passband edges to improve the signal selectivity. The tapped-line feed is adopted in this circuit to create additional attenuation poles for improving the stopband rejection levels. Experiments are conducted to verify the circuit performance.

Two dual-band bandpass filters (BPFs) based on the doubly parallel-coupled stepped impedance resonators (SIRs) structures have been proposed in this paper. The coupled-SIRs with/without open-stub-loads are introduced in the filter design. The dual-band filters exhibiting multiple zeros design operate at 2.45/5.2-GHz for the WLAN applications. Two three-staged filters composed of four SIRs have been proposed with the tapped-line adapted in the I/O sections. A five-staged filter is constructed based on the same design principle to achieve a better band-rejection. The proposed filters have the advantages of a much wider bandwidth in both the passbands without sacrificing the passband's insertion loss and passband flatness. The design procedure for a conventional parallel-coupled microstrip lines model is still suitable to design the proposed filters. The proposed filters have achieved almost twice the bandwidth of a conventional parallel-coupled lines configuration under the same design parameters. The experiments have been conducted to verify filter performance. Measured results are in good agreement with the full-wave simulation results.