In this paper, a new dimming algorithm for the electronic ballast of an electrodeless fluorescent lamp is proposed. The proposed method is based on the burst dimming method that controls the duty ratio for the two switches of the electronic ballast by intermittently modulated pulse signal. This paper presents a fully digital circuit using an erasable programmable logic device (EPLD). To verify the validity of the proposed method, the implemented control circuit was applied to the electronic ballast for a 100 W electrodeless fluorescent lamp. As a result, a dimming method with a wide illumination range from 5 to 100% was obtained.

A novel linear transconductor using translinear cells is proposed. It consists of a voltage follower, a resistor, and a current follower. SPICE simulations using an 8 GHz bipolar transistor-array parameter show that the linear transconductor with a transconductance of 1 mS exhibits a linearity error of less than 0.75% over an input voltage range of 1 V for a supply voltage of 2.0 V. The temperature coefficient of the transconductance is less than 124 ppm/. The -3-dB frequency of the transconductance is more than 4.5 GHz. Applying the linear transconductor as a building block, the design of a bandpass filter with center frequency of 85 MHz and Q-factor of 80 is presented.