Orthogonal Frequency Division Multiplexing-Direct Sequence/Code Division Multiple Access (OFDM-DS/CDMA) systems provide frequency diversity gain avoiding inter symbol interference (ISI) in a frequency selective fading channel. However, path diversity gain can not be obtained by using conventional OFDM-DS/CDMA schemes. This paper proposes a new multiple antenna transmission system with combined path diversity and frequency diversity. Signal of each antenna is delayed by several chips to create artificial path diversity as well as frequency diversity of multi-carrier transmission in which can then be combined by using a RAKE receiver. Therefore multiple antenna transmission scheme creates a path diversity effect on uncorrelated signals in multi-carriers from each antenna. The received uncorrelated signals can be processed by Maximum Ratio Combining (MRC) diversity without ISI at a RAKE receiver even when we use FFT modulation. As a result, we can obtain combined path diversity and frequency diversity gain effectively by the RAKE system with the combination of multiple antennas.

Recently, assuming ideal brick-wall transmit filtering, we proposed a frequency-domain block signal detection (FDBD) with maximum likelihood detection employing QR decomposition and M-algorithm (called QRM-MLD) for the reception of single-carrier (SC) signals transmitted over a frequency-selective fading channel. QR decomposition (QRD) is applied to a concatenation of the propagation channel and discrete Fourier transform (DFT). However, a large number of surviving paths is required in the M-algorithm to achieve sufficiently improved bit error rate (BER) performance. The introduction of filtering can achieve improved BER performance due to larger frequency diversity gain while keeping a lower peak-to-average power ratio (PAPR) than orthogonal frequency division multiplexing (OFDM). In this paper, we develop FDBD with QRM-MLD for filtered SC signal reception. QRD is applied to a concatenation of transmit filter, propagation channel, and DFT. We evaluate BER and throughput performances by computer simulation. From performance evaluation, we discuss how the filter roll-off factor affects the achievable BER and throughput performances and show that as the filter roll-off factor increases, the required number of surviving paths in the M-algorithm can be reduced.

For an indoor area where a target node is tracked with anchor nodes, we can calculate the priori probability density functions (pdfs) on the distances between the target and anchor nodes by using its shape, three-dimensional sizes and anchor nodes locations. We call it “the area layout information (ALI)” and apply it for two indoor target tracking methods with received signal strength indication (RSSI) assuming a square location estimation area. First, we introduce the ALI to a target tracking method which tracks a target using the weighted sum of its past-to-present locations by a simple infinite impulse response (IIR) low pass filter. Second, we show that the ALI is applicable to a target tracking method with a particle filter where the motion of the target is nonlinearly modelled. The performances of the two tracking methods are evaluated by not only computer simulations but also experiments. The results demonstrate that the use of ALI can successfully improve the location estimation performance of both target tracking methods, without huge increase of computational complexity.

In this paper, we propose a novel frequency-hopping scheme in order to improve the BER (Bit Error Rate) performance of the Partial Block MC-CDMA (PB/MC-CDMA) system. The joint carrier distribution and frequency hopping (JDFH) scheme achieves the optimal frequency diversity gain while avoiding interference. By contrast, the conventional FH scheme only avoids interference, and the frequency interleaving scheme achieves only frequency diversity. The JDFH scheme thus performs better than conventional schemes, such as carrier FH, block FH, or frequency interleaving. Through computer simulations, we confirmed the superior performance of the PB/MC-CDMA system when using the JDFH scheme.

Maximum likelihood block signal detection employing QR decomposition and M-algorithm (QRM-MLBD) can significantly improve the bit error rate (BER) performance of single-carrier (SC) transmission while significantly reducing the computational complexity compared to maximum likelihood detection (MLD). However, its computational complexity is still high. In this paper, we propose the computationally efficient 2-step QRM-MLBD. Compared to conventional QRM-MLBD, the number of symbol candidates can be reduced by using preliminary decision made by minimum mean square error based frequency-domain equalization (MMSE-FDE). The BER performance achievable by 2-step QRM-MLBD is evaluated by computer simulation. It is shown that it can significantly reduce the computational complexity while achieving almost the same BER performance as the conventional QRM-MLBD.

Recently, overlap frequency-domain equalization (FDE) based on minimum mean square error (MMSE) criterion which requires no guard interval (GI) insertion was proposed for signal transmission using multi-code direct sequence code division multiple access (DS-CDMA) in a frequency-selective fading channel. Another promising equalization technique is time-domain sliding-window chip equalization (SWCE). In this paper, the bit error rate (BER) performances achievable with overlap FDE and SWCE are compared. It is shown that, by extending the fast Fourier transform (FFT) block size, overlap FDE can achieve almost the same BER performance as SWCE with much less computational complexity than SWCE.

We propose a distributed node selection (DNS) scheme that guarantees quality of service (QoS) of the scalable video broadcasting system over wireless channels. The proposed DNS scheme chooses the destination node based on the SVC layer information, and it selects the best relay from a set of competing candidate nodes by considering two factors: 1) wireless channel conditions between destination and relay candidates and 2) scalable video's layer information. In simulations, the performance of the proposed scheme in terms of quality gains, complexity (overhead) and applicability was examined.

We propose Adaptive Resource Allocation for the Partial Block MC-CDMA (ARA-PB/MC-CDMA) system. The ARA-PB/MC-CDMA system aims to improve total throughput performance and frequency efficiency across various channel conditions. It adaptively changes the number of blocks to improve the throughput performance and frequency efficiency according to the Signal to Interference Ratio (SIR). Therefore, the proposed system supports various Quality of Service (QoS) requirements for various SIR values.

In this paper, we investigate the resource and power allocation schemes of partial block multi-carrier code division multiple access (PB/MC-CDMA) systems. In our proposed scheme, we manage transmit power depending on each user's channel state information (CSI). The objective is to maximize the average bit error ratio (BER) performance with minimal influence from the received signal-to-interference ratio (SIR), both of which are closely related to transmit power. To obtain additional performance improvement, our frequency band rearrangement scheme follows the transmit power control (TPC) process. We evaluate the performance of the proposed scheme using simulations. The results show that the proposed system provides superior performance compared to those of conventional systems.

In a wireless multi-hop network between a source node (S) and a destination node (D), multipath routing in which S redundantly sends the same packets to D through multiple routes at the same time is effective for enhancing the reliability of the wireless data transmission by means of route diversity. However, when applying the multipath routing to a factory where huge robots are moving around, if closer multiple routes are selected, the probability that they are blocked by the robots at the same time becomes higher, so the reliability in terms of packet loss rate cannot be enhanced. In this paper, we propose a multipath routing method which can select physically distant multiple routes without any knowledge on the locations of nodes. We introduce a single metric composed of “the distance between routes” and “the route quality” by means of scalarization in multi-objective maximization problem and apply a genetic algorithm (GA) for searching for adequate routes which maximize the metric. Computer simulation results show that the proposed method can adaptively control the topologies of selected routes between S and D, and effectively reduce the packet loss rates.

MIMO-OFDM systems are widely used in next generation wireless communications due to their high data rates, spatial division multiplexing, and robustness against channel fading. Moreover, multimedia video service is developing very quickly, as are service demands. Consequently, in order to satisfy these demands, we use a MIMO-OFDM system with SDM characteristic to transmit Scalable Video Coding (SVC) signals; our approach maximizes throughput and greatly improves video quality. We propose an Unequal Antenna Power Allocation (UAPA) scheme to improve system performance by increasing the PSNR compared to that of conventional equal power transmission systems and to efficiently utilize the power. We evaluate the performance of the proposed scheme using simulations. The results show that the proposed system provides superior performance compared to conventional systems.

In a typical indoor environment such as in a building, delay spread tends to be small, which causes frequency non-selective fading. Therefore resolvable paths at the RAKE receiver can not be obtained, and effective path diversity can not be achieved. This paper proposes an artificial path diversity system in which one or multiple sectors at the base station are pre-selected according to the channel conditions for transmitting data. Each sector's signal is delayed by several chips to create artificial paths which can then be combined by using a RAKE receiver at the mobile station creating a diversity effect for an indoor environment. Moreover, only pre-selected sector antennas transmit signals to reduce inefficient signal usage in the sectors whose paths are blocked by using all sectors, therefore the transmission power is used efficiently at the base station. As a result of sector selection, the better BER performance and the reduction of interference signals between different channels can be achieved by means of sector selection. The performance of the proposed system is analyzed and demonstrated by computer simulation in a Rayleigh and log-normal fading indoor environment.

In this paper, we propose a new transmitter diversity. We propose a combined system with path diversity gain of the distributed antennas and frequency diversity gain of the multi-carrier. The proposed system transmits different data using several sub-carriers which are correlated, while, transmitting the same data using several sub-carriers which are decorrelated. It can achieve combined path and frequency diversity in a variable frequency selective fading channel. It provides high data rate services by transmitting the different data using each correlated carrier, and supports good quality by transmitting the same data on decorrelated carriers using multiple antennas. The proposed system is applicable to multimedia service and can achieve high quality according to channel condition. Thus, the proposed system is sufficiently flexible enough to very support a variety of video, image, voice and data services at a high level of quality.

In this letter we proposed the linear combination of two ISI-free pulses with different decay rates in order to obtain a new Nyquist pulse. The proposed pulse contains a new design parameter β, giving an additional degree of freedom to minimize the bit error probability performance in the presence of symbol-timing errors, for a given roll-off factor α. Several practical tools are implemented for evaluating the performance of the proposed filter. The novel pulse is evaluated in terms of the bit error probability performance in the presence of symbol-timing errors. Eye diagrams are presented to visually assess the vulnerability of the transmission system to ISI, and the maximum distortion is estimated as a quantitative measure of performance.