With DCT coding, block artifact and mosquito noise degradations appear in decoded pictures. The control of post filtering is important to reduce degradations without causing side effects. Decoding information is useful, if the filter is inside or close to the encoder; however, it is difficult to control with independent post filtering, such as in a display. In this case, control requires the estimation of the artifact from only the decoded picture. In this work, we describe an estimation method that determines the mosquito noise block and level. In this method, the ratio of spatial activity is taken between the mosquito block and the neighboring flat block. We test the proposed method using the reconstructed pictures which are coded with different quantization scales. We recognize that the results are mostly reasonable with the different quantizations.

The non-reference method is widely useful for picture quality estimation on the decoder side. In other work, we discussed pure non-reference estimation using only the decoded picture, and we proposed quantitative estimation methods for mosquito noise and block artifacts. In this paper, we discuss the estimation method as it applies to the degradation of the temporal domain. In the proposed method, motion compensated inter-picture differences and motion vector activity are the basic parameters of temporal degradation. To obtain these parameters, accurate but unstable motion estimation is used with a 1/16 reduction of processing power. Similar values of the parameters in the pictures can be seen in the stable original picture, but temporal degradation caused by the coding increases them. For intra-coded pictures, the values increase significantly. However, for inter-coded pictures, the values are the same or decrease. Therefore, by taking the ratio of the peak frame and other frames, the absolute value of the temporal degradation can be estimated. In this case, the peak frame may be intra-coded. Finally, we evaluate the proposed method using coded pictures with different quantization.

DCT encoding of images leads to block artifact and mosquito noise degradations in the decoded pictures. We propose an estimation to determine the mosquito noise block and level; however, this technique lacks sufficient linearity. To improve its performance, we use the sub-divided block for edge effect suppression. The subsequent results are mostly linear with the quantization.

The non-reference method is widely useful to estimation picture quality on the decoder side. In this paper, we discuss the estimation method for spatial blur that divides the frequency zones by the absolute value of 64 coefficients with an 8-by-8 DCT and compares them. It is recognized that absolute blur estimation is possible with the decoded picture only.