The reception quality of terrestrial digital broadcasting when the directional pattern of a mobile terminal is controlled has been experimentally evaluated using test signal. It was found that the reception probabilities with a controlled directional pattern were significantly improved over the case when an omni-directional antenna was used.

In this paper, we propose a new concept of receiver structure with diversity reception technique to realize multi-service simultaneous reception, which shares diversity branches between receiving communication services. In the proposed receiver structure, each diversity branch selects the receiving services dynamically according to channel states, and each communication service is always selected by at least one branch to realize multi-service simultaneous reception. A basic algorithm is also described to select combinations of a diversity branch and a receiving communication service. The total number of branches decreases and the effective number of branches per communication service increases, by sharing the branches between communication services in the proposed receiver. Simulation results are shown that the proposed diversity receiver achieves both complexity reduction and performance improvement.

In an orthogonal frequency division multiplexing (OFDM) system, the bit error performance is degraded in the presence of multiple propagation paths whose excess delays are longer than the Guard Interval (GI), because the orthogonality between subcarriers cannot be maintained. Therefore, the GI has to be long enough for an expected delay spread of the channel. On the other hand, a long GI causes a decrease in transmission efficiency. In this paper, we propose a new OFDM demodulation method with a variable effective symbol duration, in order to improve the bit error performance in the presence of multipaths whose excess delays are longer than the GI. The proposed method can realize more stable radio communication systems under a multipath propagation environment even if a propagation path whose excess delay is longer than the GI exists. In other words, the proposed method can improve transmission efficiency without performance degradation by a shortened GI under the same environment. The principle of the proposed method is explained, and the bit error probability of the proposed method is analyzed theoretically in an AWGN channel and a multipath fading channel. The performance of the proposed method is then evaluated by computer simulation. The results show that the proposed method improves the system availability under more various multipath fading environments without changing the system parameters.

The DC component suppressing method, called Guided Scrambling (GS), has been proposed, where a source bit stream within a data block is subjected to several kinds of scrambling and a RLL (Run Length Limited) coding to make the selection set of channel bit streams, then the one having the least DC component is selected. Typically, this technique uses a convolutional operation or GF (Galois field) conversion. A review of their respective symbol error properties has revealed important findings. In the former case, the RS (Reed-Solomon) decoding capability is reduced because error propagation occurs in descrambling. In the latter case, error propagation of a data block length occurs when erroneous conversion data occurs after RS decoding. This paper introduces expressions for determining the decoded symbol error probabilities of the two schemes based on these properties. The paper also discusses the difference in code rates between the two schemes on the basis of the result of calculation using such expressions.