Multi-hop cooperative communication has been investigated in order to overcome disadvantages such as fading, obstruction and low power. In addition, with the goal of increasing access capacity, the orthogonal frequency division multiplexing (OFDM) modulation is being advanced as a solution. In this paper, we propose the approach of relay ordering in a Decode-and-Forward OFDM scheme. Combining techniques such as maximal ratio combining and selection combining are employed at receivers and approximate outage capacity probabilities are derived for evaluating system performance over frequency selective Rayleigh fading channels. Final, the expressions are validated by Monte-Carlo simulations, and are used to compare with the same scheme based relay selection.

In this paper, we analyze a cooperative communication network with multi energy-harvesting and decode-and-forward relays in which the best relay is selected based on criteria such as Maximizing First-Hop Signal to Noise Ratios (SNRs) (MFHS protocol), Maximizing Second-Hop SNRs (MSHS protocol), and Maximizing End-to-End SNRs (MEES protocol). In these protocols, the relays apply power-splitting receivers to harvest energy from radio frequency signals emitted from a source. Thus, each received SNR in the second hop is a function of a direct relay-destination gain and an indirect source-relay gain. The system performance of the proposed protocols is evaluated via exact outage probability analyses and Monte Carlo simulations. For further comparisons, an energy-harvesting decode-and-forward scheme with randomly relay selection (RRS protocol) and an energy-harvesting amplify-and-forward scheme (BAF protocol) are investigated and discussed. The simulation results show that 1) the MEES protocol outperforms the MFHS and MSHS protocols, and the MFHS protocol is more efficient than the MSHS protocol in the low SNR regions; 2) the proposed protocols achieve the best performance at the specific optimal power splitting ratios for which the MEES protocol has a balanced ratio for energy harvesting and decoding capacity; and 3) the theoretical analyses agree well with the simulation results.

In this paper, an energy harvesting architecture in an Underlay Cooperative Cognitive Network (UCCN) is investigated, in which power constrained Decode-and-Forward relays harvest energy from radio-frequency signals received from a source, and then consume the harvested energy by forwarding the recoded signals to their destination. These recoded signals are launched by a transmitting power which is the harvested energy per a time interval. Based on the energy harvesting architectures that have been studied, two operation protocols are proposed: UCCN with Power Splitting architecture (UCCN-PS), and UCCN with Time Switching architecture (UCCN-TS). The best cooperative relay in both protocols is taken to be the one that satisfies the following conditions: maximum harvested energy, and maximum decoding capacity. As a result of the best relay selection, the signal quality of the selected link from the best relay to the destination is enhanced by the maximum harvested energy. The system performance of the secondary network in the UCCN-PS and UCCN-TS protocols is analyzed and evaluated by the exact closed-form outage probabilities and throughput analyses over Rayleigh fading channels. The Monte Carlo simulation method is performed to verify the theoretical expressions. Evaluations based on outage probability and throughput show that the system performance of the secondary network in the UCCN-PS and UCCN-TS protocols improves when the number of cooperative relays and the interference constraint increase as well as when the primary receiver is farther from the transmitting nodes such as the source and relays of the secondary network. In addition, the throughput performance of the UCCN-PS protocol outperforms that of the UCCN-TS protocol. Finally, the effects of the power splitting ratio, energy harvesting time, energy conversion efficiency, target Signal-to-Noise Ratio (SNR), and location of cooperative relays on the system performance of the secondary network are presented and discussed.