Bandwidth and gain enhancement of microstrip patch antennas (MPAs) is proposed using reflective metasurface (RMS) as a superstrate. Two different types of the RMS, namely- the double split-ring resonator (DSR) and double closed-ring resonator (DCR) are separately investigated. The two antenna prototypes were manufactured, measured and compared. The experimental results confirm that the RMS loaded MPAs achieve high-gain as well as bandwidth improvement. The desinged antenna using the RMS as a superstrate has a high-gain of over 9.0 dBi and a wide impedance bandwidth of over 13%. The RMS is also utilized to achieve a thin antenna with a cavity height of 6 mm, which is equivalent to λ/21 at the center frequency of 2.45 GHz. At the same time, the cross polarization level and front-to-back ratio of these antennas are also examined.

New microstrip bandpass filters with extended stopband bandwidths are proposed by using new asymmetric stepped-impedance hairpin resonators (ASIHRs). The size of the proposed resonators has been reduced around 16%, comparing with the conventional stepped-impedance hairpin resonators (SIHRs) structure. The first bandpass filter is a combination of differ resonators with the same fundamental frequency but differ in harmonic frequencies, resulting in improved suppression spurious responses in stopbands. Furthermore, another bandpass filter uses the ASIHRs periodically loaded on a microstrip line to improve stopband characteristics. The proposed filters not only have compact size of resonators, but also provide improved upper stopband characteristics. The proposed filters provide 20 dB rejection levels in the stopband up to 6f0. The measured filters responses agree very well with the simulated expectations.

By inserting a slot and metallic strips at the widened stub in a single layer and fed by coplanar waveguide (CPW) transmission line, novel dual-band and broadband operations are presented. The proposed antennas are designed to have dual-band operation suitable for applications in DCS (1720-1880 MHz), PCS (1850-1990 MHz), IMT-2000 (1920-2170 MHz), and IEEE 802.11 WLAN standards in the 2.4 GHz (2400-2484 MHz) and 5.2 GHz (5150-5350 MHz) bands. The dual-band antennas are simple in design, and the two operating modes of the proposed antennas are associated with perimeter of slots and loading metallic strips, in which the lower operating band can be controlled by varying the perimeters of the outer square slot and the higher band depend on the inner slot of the widened stub. The experimental results of the proposed antennas show the impedance bandwidths of the two operating bands, determined from 10-dB return loss, larger than 61% and 27% of the center frequencies, respectively.

In this paper, CPW-fed slot antennas using loading metallic strips and a widened tuning stub (CPW-FSLW) which provides wideband operation on the flat, a Λ-shape reflector with horizontal plate that prevents the back radiation and provides the uni-directional radiation are investigated. We observe that the size and shape of the reflector have significant impact on the impedance matching and radiation patterns. By fabricating the CPW-FSLW on the Λ-shape reflector with horizontal plate structure, noticeable enhancements in both radiation pattern and bandwidth are achieved. The antennas are verified both through numerical simulations and also measurements of the experimental prototypes and these confirm the good performance antennas. It is found that the proposed antenna can deliver a measured impedance bandwidth of 64% from 1.6 to 3.1 GHz for VSWR ≤ 2. The antennas are designed to have wideband operation suitable for applications in GSM1800, GSM1900, PCS, IMT-2000 and WLAN bands.