In wireless sensor networks constructed from battery driven nodes, it is difficult to supply electric power to the nodes. Because of this, the power consumption must be reduced. To cope with this problem, clustering techniques have been proposed. EACLE is a method that uses a clustering technique. In EACLE, route selection is executed independently after the CH (Cluster Head) selection. This two-phase control approach increases overheads and reduces the battery power, which shortens the lifetime of wireless sensor networks. To cope with this problem, we have proposed a novel routing and clustering method called PARC for wireless sensor networks that reduces these overheads by integrating the cluster selection phase and the route construction phase into a single phase. However, PARC has a weak point in that the batteries of CHs around the sink node are depleted earlier than the other nodes and the sink node cannot collect sensing data. This phenomenon is called the hot spot problem. In order to cope with this problem of PARC, we propose PARC+, which extends the CH selection method of PARC such as more nodes around the sink can be selected as a CH node. We evaluate our proposed methods by simulation experiments and show its effectiveness.

We propose novel tree construction algorithms for multicast communication in photonic networks. Since multicast communications consume many more link resources than unicast communications, effective algorithms for route selection and wavelength assignment are required. We propose a novel tree construction algorithm, called the Weighted Steiner Tree (WST) algorithm and a variation of the WST algorithm, called the Composite Weighted Steiner Tree (CWST) algorithm. Because these algorithms are based on the Steiner Tree algorithm, link resources among source and destination pairs tend to be commonly used and link utilization ratios are improved. Because of this, these algorithms can accept many more multicast requests than other multicast tree construction algorithms based on the Dijkstra algorithm. However, under certain delay constraints, the blocking characteristics of the proposed Weighted Steiner Tree algorithm deteriorate since some light paths between source and destinations use many hops and cannot satisfy the delay constraint. In order to adapt the approach to the delay-sensitive environments, we have devised the Composite Weighted Steiner Tree algorithm comprising the Weighted Steiner Tree algorithm and the Dijkstra algorithm for use in a delay constrained environment such as an IPTV application. In this paper, we also give the results of simulation experiments which demonstrate the superiority of the proposed Composite Weighted Steiner Tree algorithm compared with the Distributed Minimum Hop Tree (DMHT) algorithm, from the viewpoint of the light-tree request blocking.