The stability of a high-resistivity load SRAM cell using thin-film SOI MOSFET's was investigated as compared with bulk-Si MOSFET's. In SOI MOSFET's back-gate-bias effect was suppressed by indirect application of back-gate-bias to the channel region through the thick buried oxide. The Vt shifts were reduced to be 10% and 14% of that in bulk-Si MOSFET's in partially and fully depleted devices, respectively. The reduction of back-gate-bias effect provides improvement of "high" output voltage and gain in the enhancement-enhancement (EE) inverter in a high-resistivity load SRAM cell, thereby offering improved cell stability. It was demonstrated by using partially depleted SOI SRAM cells that non-destructive reading was obtained even at a low drain voltage of 1.4 V without gate-potential boost, which was much smaller than the operation limit in a bulk Si SRAM with the same patterns and dimensions used as a reference. This implies that SOI devices can also offer low-voltage operation even in TFT-load cells used in up-to-date high-density SRAM's. These results suggest that thin-film SOI MOSFET's have a superior potential of low-voltage operation expected for further scaled devices and/or for portable systems in a forthcoming multimedia era.

A novel CMOS structure has been developed using Ti-salicide PSD transistor formed by a new self-aligned method. Both N-channel and P-channel PSD transistors exhibit excellent short-channel behaviors down to the sub-half-micrometer region with shallow S/D junctions formed by dopant diffusion from polysilicons. New salicide process has been developed for the PSD structure and can effectively reduce the sheet resistances of the S/D polysilicon and the polysilicon gate to as low as 45Ω/. As a result, the low resistive local interconnects can be successfully implemented by the Ti-salicide S/D polysilicon merged with contacts by self-alignment. More-over it is found that shallow Ti-salicide S/D junctions with the PSD structure can achieve approximately 12 orders of magnitude lower area leakage current than that of the conventional implanted S/D junctions by eliminating implanted damage and preventing penetration of silicide into junctions with the elevated structure of S/D polysilicon layer. Furthermore CMOS ring oscillators having PSD transistors with an effective channel length of 0.4 µm were fabricated using the salicided S/D polysilicon as a local interconnect between the N+ and the P+ regions, and successfully operated with a propagation delay time of 50 ps/stage at a supply voltage of 5 V.