This paper describes an adaptively weighted code division multiplexing (AW-CDM) system, in other words, power controlled spread-spectrum multiplexing system and describes its application to hierarchical digital broadcasting of television signals. The AW-CDM, being combined with multi-resolutional video encoder, can provide such a hierarchical transmission that allows both high quality services for fixed receivers and reduced quality services for mobile/portable receivers. The carrier and the clock are robustly regenerated by using a spread-spectrum multiplexed pseudorandom noise (PN) sounder as a reference in the receiver. The PN reference is also used for Rake combining with signals via different paths, and for adaptive equalization (EQ). In a prototype AW-CDM modem, three layers of hierarchical video signals (highs: 5.91Mbps, middles: 1.50Mbps, and lows: 0.46 Mbps) are divided into a pair of 64 orthogonal spread-spectrum subchannels, each of which can be given a different priority and therefore a different threshold. In this case, three different thresholds are given. The modem's transmission rate is 9.7Mbps in the 6MHz band. Indoor transmission tests confirm that lows (weighted power layer I), middles (averaged power layer II), and highs (lightened power layer III) are retrievable under conditions in which the desired to undesired signal ratios (DURs) are respectively 0dB, 8.5dB, and 13.5dB. If the undesired signals are multipaths, these performances are dramatically improved by Rake combining and EQ. The AW-CDM system can be used for 20-30 Mbps advanced television (ATV) transmission in the 6-MHz bandwidth simply by changing the binary inputs into quaternary or octonary inputs.

We propose a method of reducing laser-clipping-induced distortion in a subcarrier multiplexed (SCM) optical-cable TV system. This scheme reduces amplitude peaks of the SCM signal by controlling the phases of video carriers to prevent the clipping which occurs when these peaks fall below the threshold of a laser-diode. It is experimentally shown that using this method reduces the bit error rate in an AM-VSB / QAM hybrid optical-transmission system.

The statistical behavior of the amplitude probability distribution of intermodulation distortion interference in multichannel optical-cable TV systems was experimentally investigated. In multichannel transmission, the non-linearity of a laser diode (LD) or an electrical amplifier can cause intermodulation distortion (composite-second-order beat; CSO, composite-triple-beat; CTB, etc. ). Even though it has been discussed as laser-clipping distortion, intermodulation distortion is usually distortion from AM-VSB carriers. The statistical analysis and evaluation of the distortion in transmitted channel is in controversial. We evaluated the distortion in 20 frequency-division-multiplexed 16-QAM channels, with each carrier carrying 80 Mbps for an optical cable TV system. We first enumerated the distortion components causing interference in each transmission channel so as to identify the intermodulation products. Then, in selected channels, we precisely measured the power of each kind of distortion and the amplitude distributions of the intermodulation distortion from sinusoidal and digital-modulated carriers on cable TV as a function of optical modulation depth (OMD) of LD. And we clarified how the probability distribution function (PDF) changed as the OMD increased. Also, the BER performance of a 16-QAM signal was measured and compare to the intermodulation behavior of the different distortion sources. We found evidence that the amplitude distribution of intermodulation distortion from digital carriers differs from that of thermal noise. Experimental results showed that the PDF of the intermodulation distortion changed when the ratio of intermodulation distortion among all undesired signals varied with the OMD. The BER performance varied with intermodulation of both analogue and digital carriers even when the carrier to interference noise power ratio (CIR) is the same.

The statistical behavior of the amplitude probability distribution of intermodulation distortion interference in multichannel optical-cable TV systems was experimentally investigated. In multichannel transmission, the non-linearity of a laser diode (LD) or an electrical amplifier can cause intermodulation distortion (composite-second-order beat; CSO, composite-triple-beat; CTB, etc. ). Even though it has been discussed as laser-clipping distortion, intermodulation distortion is usually distortion from AM-VSB carriers. The statistical analysis and evaluation of the distortion in transmitted channel is in controversial. We evaluated the distortion in 20 frequency-division-multiplexed 16-QAM channels, with each carrier carrying 80 Mbps for an optical cable TV system. We first enumerated the distortion components causing interference in each transmission channel so as to identify the intermodulation products. Then, in selected channels, we precisely measured the power of each kind of distortion and the amplitude distributions of the intermodulation distortion from sinusoidal and digital-modulated carriers on cable TV as a function of optical modulation depth (OMD) of LD. And we clarified how the probability distribution function (PDF) changed as the OMD increased. Also, the BER performance of a 16-QAM signal was measured and compare to the intermodulation behavior of the different distortion sources. We found evidence that the amplitude distribution of intermodulation distortion from digital carriers differs from that of thermal noise. Experimental results showed that the PDF of the intermodulation distortion changed when the ratio of intermodulation distortion among all undesired signals varied with the OMD. The BER performance varied with intermodulation of both analogue and digital carriers even when the carrier to interference noise power ratio (CIR) is the same.