Gas flow in arc quenching chamber has an important effect on the interruption capability of low voltage circuit breakers. In this paper, based on a simplified model of arc chamber with a single break, which can be opened by the electro-dynamics repulsion force automatically, the effect of different vent configurations including middle vent and side vent on the interruption performance is investigated. First, the experiments are carried out to compare the different performance in the interruption process between middle vent type and side vent type. In addition, according to the experimental model, a 3-D magneto-hydrodynamic model was developed by adapting and modified the commercial computational fluid dynamics software FLUENT. The simulation results show the same trend in arc motion as explained in the experimental conclusions in theory.

An electrical arc is generated by opening the contacts of a relay when the current is above the minimum arc current in a circuit. A magneto-hydrodynamic (MHD) model was employed to simulate this dynamic arcing process. The distributions of arc parameters such as temperature, electrical field and magnetic flux density generated by opening the contacts in a circuit with a 5 A DC low current were obtained. The behaviors of the arc parameters with increasing gap length between the contacts were also simulated. The MHD model was then combined with structured dynamic layering, which is a dynamic meshing technique of computational fluid dynamics (CFD) to calculate the dynamic arcing process, and the arc parameters generated by opening the contacts in the circuit with a 5 A DC low current with a constant velocity were also obtained. It turned out that the computed time-varying contact voltage and arc duration agreed well with the test results. Thus, the validity of the simulation was demonstrated.

This paper focuses on the numerical and experimental investigations of the influence of two polymers (PA6 and POM) on the arc behavior during arc motion process. The mathematical model of 3-dimentional air arc plasma considering the ablation of lateral walls is built based on magnetic hydro-dynamics (MHD). By adopting the commercial computational fluid dynamics (CFD) package based on control-volume method, the above MHD model is solved and the distribution of temperature field, concentration field, flow field and electrical potential field in the arc chamber are calculated. The simulation results indicate that the vapor concentration behind the arc column is higher than that in front of the arc column because of the existence of "double vortices" in the arc chamber. The use of polymers causes the maximal arc voltage increase 16.2% with POM and 18.9% with PA6 in this case and causes the average arc velocity increase 15.8% with POM and 21.1% with PA6 in this case. The experiments are also carried out to study the influence of polymers on arc voltage and arc root position in the arc chamber during arc motion. The experimental results prove the validity of the numerical investigation.

A two-dimensional compressible magnetohydrodynamic (MHD) computational model has been developed to study the effect of gassing material on air arc behavior in low voltage circuit breaker. The properties of arc plasma and the electric, magnetic and radiative phenomena have been taken into account in the model. Based on the model, steady state solutions have been performed to study the effect of gassing material on the arc radius and electric field in the arc column. Then, the effect of gassing material on the transient process of arc motion also has been simulated. In addition, using the two-dimensional optical fiber measurement system, experiments have been done to measure the average velocity of arc motion with one model chamber and to verify the simulation model and prediction results. It demonstrates that the action of gassing material may yield the stronger electric field, less arc radius and higher arc motion velocity.