A full-wave analysis for the scattering problem of infinite periodic arrays on dielectric substrates excited by a circularly-polarized incident wave is presented. The impedance boundary condition is solved by using the moment method in the spectral domain. Numerical results are given and scattering properties are discussed.

Numerical analysis of the electromagnetic radiation from conducting surface structures is concerned. The method of moments is discussed with the surface-patch modeling in which the surface quantities, i.e. the current, charge and impedance are directly introduced and with the wire-grid modeling in which the surface quantities are approximated by the filamentary traces. The crucial element to a numerical advantage of the wire-grid modeling lies in the simplicity of its mathematical involvements that should be traded for the uncertainties in the construction of the model. The surface-patch techniques are generally not only clear and straightforward but also more reliable than the wire-grid modeling for the computation of the surface quantities. In this work, we bring about a comparative discussion of the two approaches while the analysis of a built-in planar antenna is reported. For the purpose of the comparison, the same electric field integral equation and the Galerkin's procedure with the linear expansion/testing functions are used for both the wire-grid and surface-patch modeling.

In order to explain the temperature and frequency characteristics of high-Tc superconductors, a new model is proposed, which will be called the improved three-fluid model, where the momentum relaxation time τ is assumed to depend on temperature in the superconducting and normal states, respectively, although τ has been assumed to be independent of temperature for the conventional three-fluid model. According to this model, the complex conductivity σ1jσ2 and the surface impedance ZsRsjXs, where Rs is the surface resistance and Xs is the surface reactance, are expressed as a function of temperature. The temperature dependences of Zs and for a YBCO bulk estimated using this model agree very well with ones measured by the dielectric-loaded cavity method in room to cryogenic temperature. In particular, a peak of σ1 observed just below the critical temperature Tc in experiments, appeared in the calculated results based on this model. This phenomenon has been already known in the BCS theory. Thus, it is verified that this model is useful to explain the microwave characteristics of high-Tc superconductors in room to cryogenic temperature. On the other hand, the residual normal electron density nres4.2541023 m-3 and the total electron density nt7.3081024 m-3 are obtained by calculation. The ratio nres/nt0.058 can be used as figure of merit to evaluate material quality of high-Tc superconductors; thus it means that there is 5.8% nonpairing electron in this YBCO bulk.

Numerical solutions for the near-field of microstrip antennas are presented. The field distribution is calculated by taking the inverse Fourier transform involving the current distribution with the help of the spectral-domain moment method. A new technique to save the computation time is devised, and the field pattern of the circularly polarized antenna is illustrated.

An accurate numerical solution is presented for the electromagnetic scattering from a double strip grating, where the strip planes are each supported by a dielectric slab. This structure is a model of polarization diplexers. The direction of propagation and the polarization of the incident plane wave are arbitrary. We derive a set of singular integral equations and solve it by the moment method, where the Chebyshev polynomials are successfully used as the basis and the testing functions. By numerical computations we examine the dependence of the diplexing properties on grating parameters in detail. The cross-polarization characteristics at skew incidence are also referred. From these results we construct an algorithm for the design of polarization diplexers.

This paper describes the higher-order moment analysis of superposed Markov jumping processes. A superposed Markov jumping process is defined as a linear superposition of a finite number of piecewise constant real valued stochastic process whose value changes are associated with state transitions in an underlying descrete state continuous time Markov process. Some phenomena are modeled well by the process such as membrane current fluctuations observed at bio-membranes or load fluctuations in electrical power systems. Theoretical formula of the moment function of any order k is derived and the parameter estimation problem utilizing higher-order moment functions is discussed. A new method of estimating the kinetic parameters of membrane current fluctuations is proposed as a possible application.

Frequency Selective Screens (FSS) with conductor or complementary aperture array are investigated. The electric current distribution on conductor or the magnetic current distribution on aperture is determined by the moment method in the spectral domain. In addition, the power reflection coefficients are calculated and the scattering properties are considered.

An accurate numerical solution is presented for the electromagnetic scattering from infinite strip gratings attached to both sides of a dielectric slab. This structure is a model of polarization discriminating devices. The period of the strips is common to both planes, but the widths and the axes may be different. The direction of propagation and the polarization of an incident plane wave are arbitray. We derive a set of singular integral equations and solve it by the moment method, where the Chebyshev polynomials are successfully used as the basis and the testing functions. This method is accurate and effective owing to the incorporation of the edge condition and the decomposition of the kernel functions into the singular and the regular parts. Numerical calculations are carried out for the purpose of designing polarization discriminators, and it is shown that the band width is widened by decreasing the permittivity of the slab. The cross-polarization characteristics at skew incidence are also discussed.

The selection method of the moment of inertia of the flywheel in a digital measurement system of torque-speed curve plotting for a kind of motor is presented. The selection standards of the moment of inertia and the map displaying the operating ranges of the measurement system are shown. The selection procedure of the moment of inertia is also shown.

Quantization of the impulse response coefficients due to finite word length causes the moments to deviate from their ideal values. This deviation is found to have a linear variation with the output roundoff noise of the filter realized in direct form. Since the zeros and poles of a given filter also move away from their designed locations due to quantization, we show a relation between the zeros and poles and the moments of the impulse response.