The search functionality is under construction.
The search functionality is under construction.

Keyword Search Result

[Keyword] barium ferrite(2hit)

1-2hit
  • A Study on Signal Processing for Barium Ferrite Particulate Tape Systems

    Atsushi MUSHA  Osamu SHIMIZU  

     
    PAPER

      Vol:
    E96-C No:12
      Page(s):
    1474-1478

    The optimum generalized partial response (GPR) target for barium ferrite (BaFe) tape systems was studied. The shift in perpendicular magnetic recording technology in HDDs to systems employing single-pole-type (SPT) recording heads and media with a soft under layer (SUL) has been accompanied by a change in the read channel design, whereas current magnetic tape recording systems utilize a combination of a ring-type recording head with a single magnetic layer structured medium. Therefore, the read channel performance of current oriented BaFe particulate tape systems needs to be studied to best exploit the potential of this medium. Toward this end, DC-free, DC-full, and DC-suppressed targets were compared. The results show that assuming a GPRML detector with 16 or more states, a traditional DC-free target exhibits the best bit error rate performance for both longitudinally and perpendicularly oriented BaFe media, suggesting that the current read channel designed for longitudinally oriented media can also be utilized for BaFe particulate tape systems.

  • Development of Particulate Recording Media with Ultrathin Magnetic Layer

    Hiroo INABA  Shinji SAITOH  Toshiyuki KITAHARA  Akira KASHIWAGI  

     
    PAPER

      Vol:
    E78-C No:11
      Page(s):
    1536-1542

    A particulate recording medium with an ultrathin magnetic layer is presented in this paper. This medium consists of a magnetic layer and a nonmagnetic underlayer composed of very fine titanium dioxide powder. When metal powder was employed, we observed the anticipated advantages of decreasing the thickness of the magnetic layer in tapes and diskettes. By reducing the layer thickness to below 0.3 µm we were able to increase the reproduced output at short wavelengths, and improve both the overwrite erasability and the D50. There was also a decrease in the half peak width of an isolated pulse and a peak shift. Tribological advantages were also observed with this medium. When barium ferrite was employed as the magnetic powder, we observed that the modulation noise of thin-layer barium ferrite medium was less than that of a thinlayer MP medium while it generated an output as high as that of the MP medium. The advantages of the barium ferrite medium lie in its two-layer construction. Particulate media will continue to develop as magnetic powder is improved mainly in terms of its size, saturation magnetization, and coercivity.