1-2hit |
In a Direct-Sequence/Spread-Spectrum (DS/SS) system, a RAKE receiver is used to improve a bit error rate (BER) performance. The RAKE receiver can collect more signal energy through independent paths and achieve path diversity. The RAKE receiver obtains further diversity gain through fractional sampling. However, the power consumption of the RAKE receiver increases in proportion to a sampling rate and does not always maximize the signal-to-noise ratio (SNR). Therefore, sampling rate selection schemes have been proposed to reduce the average sampling rate without degrading the BER. These schemes select the tap positions and the sampling rate depending on channel conditions and the power consumption can be reduced. In this paper, sampling rate selection schemes for the DS/SS system are investigated through an experiment since there have been no numerical results through an experiment. Numerical results show that the power consumption can be reduced even through the experiment without the degradation of the BER.
Yohei SUZUKI Anas M. BOSTAMAM Mamiko INAMORI Yukitoshi SANADA
In this paper, sampling rate selection diversity (SRSD) scheme for Direct-Sequence/Spread-Spectrum (DS/SS) is proposed. In DS/SS communication systems, oversampling may be employed to increase the signal-to-noise ratio (SNR). However, oversampling enlarges the power consumption because signal processing of the receiver has to be carried out at a higher clock rate. Higher sampling rate does not always maximize the SNR. In the proposed SRSD scheme, the power consumption can be reduced by selecting the optimum sampling rate depending on the characteristics of the channel. The proposed SRSD scheme can also reduce the BER more than the conventional oversampling scheme under certain channel conditions.