The Ethernet passive optical network (EPON), which is one of the PON technologies for realizing FTTx (Fiber-To-The-Curb/Home/Office), is a low-cost and high-speed solution to the bottleneck problem that occurs between a backbone network and end users. The EPON is compatible with existing customer devices that are equipped with an Ethernet card. To effectively control frame transmission from optical network units (ONUs) to an optical line termination (OLT), the EPON can use a multi-point control protocol (MPCP) with control functions in addition to the media access control (MAC) protocol function. In this paper, we propose a two-phase cycle dynamic bandwidth allocation (TCDBA) algorithm to increase the channel utilization on the uplink by allowing frame transmissions during computation periods, and combine the TCDBA algorithm with the queue management schemes performed within each ONU, in order to effectively support differentiated services. Additionally, we perform simulations to validate the effectiveness of the proposed algorithm. The results show that the proposed TCDBA algorithm improves the maximum throughput, average transmission delay, and average volume of frames discarded, compared with the existing algorithms. Furthermore, the proposed TCDBA algorithm is able to support differentiated quality of services (QoS).

This paper describes the design concept and characteristics of a power supply for optical network units in Fiber To The Home (FTTH) systems. Powering architectures of local powering, network powering and power hub powering are compared in terms of cost and maintainability. A local powering architecture is selected for an ONU power supply because it is the most cost-effective overall compared with the others. The local power supply is mainly composed of a rectifier, DC-DC converters, a ringer, and batteries. A battery deterioration test function is important for the local power supply because battery lifetime varies depending on ambient temperature, discharge history, and charging conditions, and it is shorter than other electrical components used in ONU. Supplying power using alternative batteries is also necessary because the capacity of batteries installed in the power supply is limited. These functions and electrical characteristics are checked using an experimental power supply with Ni-Cd batteries.