In this paper, a novel model of Gaussian pulse propagation in optical fiber is proposed to comprehensively analyze the impact of Group Velocity Dispersion (GVD) on the performance of two-dimensional wavelength hopping/time spreading optical code division multiple access (2-D WH/TS OCDMA) systems. In addition, many noise and interferences, including multiple access interference (MAI), optical beating interference (OBI), and receiver's noise are included in the analysis. Besides, we propose to use the heterodyne detection receiver so that the receiver's sensitivity can be improved. Analytical results show that, under the impact of GVD, the number of supportable users is extremely decreased and the maximum transmission length (i.e. the length at which BER 10-9 can be maintained) is remarkably shortened in the case of normal single mode fiber (ITU-T G.652) is used. The main factor that limits the system performance is time skewing. In addition, we show how the impact of GVD is relieved by dispersion-shifted fiber (ITU-T G.653). For example, a system with 321 Gbit/s users can achieve a maximum transmission length of 111 km when transmitted optical power per bit is -5 dBm.

The dense wavelength division multiplexing (DWDM) technique is very attractive for effectively increasing the channel capability, even for access networks. Some DWDM radio-on-fiber (ROF) systems have been studied recently. In those systems, fiber Bragg gratings (FBG) or arrayed waveguide gratings (AWG) were used to demultiplex DWDM ROF signals. In this report, an alternative channel-selection scheme of DWDM millimeter-wave-band ROF signals by optical heterodyne detection with dual-mode local light is newly proposed. Error-free demultiplexing and transmission over a 25-km-long SMF of the DWDM signal, which consists of two 60-GHz-band, 155-Mb/s-DPSK ROF signals, are demonstrated.

Fiber-optic access system integration is the key to providing various kinds of services to home users. The combination of ATM- and SCM-PON systems is essential to support a high-speed data service and analog/digital video distribution services. From this viewpoint, a frequency-division- multiplexing technique for digital baseband and subcarrier multiplexed signals is required to achieve system integration. However, system integration for these two access systems has not been fully investigated yet. The SCM-PON system, which uses a super wideband optical FM converter, will enable these two different kinds of access system (ATM and SCM) to be integrated. In this paper, we describe experimentally obtained results for frequency- division-multiplexed signals consisting of digital baseband and subcarrier- multiplexed signals. The experiments were carried out using a 622-Mb/s baseband signal and an FM-converted signal containing AM and 64QAM signals. The experimental results reveal that the inter-channel interference between the digital baseband and FM-converted signals restricts the number of subcarriers for AM and 64QAM. With an intermediate frequency of 3 GHz for the FM-converted signal, an FDM signal consisting of 622-Mb/s baseband, 30 carriers of 64QAM, and 11 carriers of AM was successfully transmitted.

This paper newly proposes radio-over-fiber systems using cascaded radio-to-optic direct conversion (ROC) scheme. The ROC system can convert a radio signal into an optical signal with the same signal format. The received carrier-to-noise ratio (CNR) performance of the radio-over-fiber systems using the ROC/heterodyne detection (HD) scheme and the ROC/self-heterodyne detection (SHD) scheme are theoretically analyzed. The optimization of an optical modulation index (OMI) in each radio base station (RBS) is also presented. By using the proposed OMI optimization method, the ROC/HD and the ROC/SHD schemes are shown to provide approximately 16 dB and 14 dB improvement over the intensity modulation/direct detection scheme when the number of RBS is 20 and the radio-frequency (RF) signal bandwidth is 150 MHz, respectively. The ROC/SHD scheme enables a receiver structure to become simple while still achieving high received CNR.

Cross-phase modulation (XPM) induced by residual intensity modulation in coherent optical frequency-shift-keying (FSK) frequency division multiplexing (FDM) transmission systems that use dispersion-shifted fibers is evaluated theoretically and experimentally in terms of spectral profile deformation. The bit-error rate is measured in a 2.5-Gbit/s 4-channel 40-km dispersion-shifted fiber transmission experiment, and we confirm experimentally and theoretically that the power penalty in the presence of residual intensity modulation of over 4 mWp-p exceeds 1dB. Experimental results show that the penalty due to XPM is large even when the power of the newly generated lights caused by four-wave mixing is 20-dB less than that of signals. This confirms that residual intensity modulation must be reduced in continuous-phase (CP)-FSK-FDM systems even though they are designed to avoid generating four-wave mixing.

Photonic ATM switching systems with Terabit/s throughput are desirable for future broadband ISDN systems. Since electronic LSI-based ATM switching systems are planned to have the throughput of 160Gb/s, a photonic ATM switching system should take the role of the highest layer in a hybrid switching network which includes electronic LSI-based ATM switching systems as its sub-system. This report discusses the state-of-the-art photonic devices needed for a frequency-self-routing ATM photonic switching system with maximum throughput of 5Tb/s. This kind of systems seems to be a moderate system for the first phase photonic switching system with no insuperable obstacle for initiating development, even though none of the devices and technologies required have yet been developed to meet the specifications. On the contrary, for realizing further enlarged throughput as the second-phase photonic switching system, there are huge fundamental research projects still remaining for establishing the technology utilizing the spectrum broadened over 120nm and highly-dense FDM technologies based on homodyne coherent detection, if supposing a simple architecture. "Ultra devices" seem to be the photonic devices based on new tailored materials of which gain and refractive index are designed to realize ultra-wide spectrum utilization.