The high-availability seamless redundancy (HSR) protocol is a representative protocol that fulfills the reliability requirements of the IEC61850-based substation automation system (SAS). However, it has the drawback of creating unnecessary traffic in a network. To solve this problem, a dual virtual path (DVP) algorithm based on HSR was recently presented. Although this algorithm dramatically reduces network traffic, it does not consider the substation timing requirements of messages in an SAS. To reduce unnecessary network traffic in an HSR ring network, we introduced a novel packet transmission (NPT) algorithm in a previous work that considers IEC61850 message types. To further reduce unnecessary network traffic, we propose an extended dual virtual paths (EDVP) algorithm in this paper that considers the timing requirements of IEC61850 message types. We also include sending delay (SD), delay queue (DQ), and traffic flow latency (TFL) features in our proposal. The source node sends data frames without SDs on the primary paths, and it transmits the duplicate data frames with SDs on the secondary paths. Since the EDVP algorithm discards all of the delayed data frames in DQs when there is no link or node failure, unnecessary network traffic can be reduced. We demonstrate the principle of the EDVP algorithm and its performance in terms of network traffic compared to the standard HSR, NPT, and DVP algorithm using the OPNET network simulator. Throughout the simulation results, the EDVP algorithm shows better traffic performance than the other algorithms, while guaranteeing the timing requirements of IEC61850 message types. Most importantly, when the source node transmits heavy data traffic, the EDVP algorithm shows greater than 80% and 40% network traffic reduction compared to the HSR and DVP approaches, respectively.

Recently, Hadoop has attracted much attention from engineers and researchers as an emerging and effective framework for Big Data. HDFS (Hadoop Distributed File System) can manage a huge amount of data with high performance and reliability using only commodity hardware. However, HDFS requires a single master node, called a NameNode, to manage the entire namespace (or all the i-nodes) of a file system. This causes the SPOF (Single Point Of Failure) problem because the file system becomes inaccessible when the NameNode fails. This also causes a bottleneck of efficiency since all the access requests to the file system have to contact the NameNode. Hadoop 2.0 resolves the SPOF problem by introducing manual failover based on two NameNodes, Active and Standby. However, it still has the efficiency bottleneck problem since all the access requests have to contact the Active in ordinary executions. It may also lose the advantage of using commodity hardware since the two NameNodes have to share a highly reliable sophisticated storage. In this paper, we propose a new HDFS architecture to resolve all the problems mentioned above.

For cluster systems consisting of multiple processing nodes and shared servers which consist of an on-line and a backup shared server, we propose a hot-standby scheme for shared servers. In this scheme for shared servers, when the on-line shared server receives a command from a node, it sends only an update command and its data identifier to the backup shared server. Both the on-line and the backup shared server execute the update command independently, and the command result of the on-line shared server is identical to that of the backup shared server. When the on-line shared server fails, the backup reconstructs the shared data by using its own shared data and the user data from each node. We evaluated the system recovery time and the performance overhead for this hot-standby scheme. It enables the performance overhead to be ignored, and the system recovery time to be shortened to 20 seconds in cluster systems.