Generating conditions of the optical feedback noise in self-pulsing lasers were experimentally examined. The noise charcteristics were determined by changing the operating power, the feedback distance and the feedback ratio for several types of self-pulsing lasers. The idea of the effective modulation index was introduced to evaluate the generating conditions in an uniform manner based on the mode competition theory. Validity of the idea was experimentally confirmed for generation of noise.

Theoretical calculations of the pulsing operation and the intensity noise under the optical feedback are demonstrated for operation of the self-sustained pulsation lasers. Two alternative models for the optical feedback effect, namely the time delayed injection model and the external cavity model, are applied in a combined manner to analyze the phenomena. The calculation starts by supposing the geometrical structure of the laser and the material parameters, and are ended by evaluating the noise. Characteristics of the feedback induced noise for variations of the operating parameters, such as the injection current, the feedback distance and the feedback ratio, are examined. A comparison to experimental data is also given to ensure accuracy of the calculation.

Mechanism of the noise generation caused by the optical feedback in semiconductor laser was experimentally determined. Two types of the mode competition phenomena were confirmed to be the generating mechanisms. Applicability of the self-sustained pulsation to be a noise reduction method was also discussed.

This paper proposes a method to predict and control noise voltage caused by electrostatic discharge (ESD) to electronic equipment. The relationship of grounding system configurations for a typical set of equipment to ESD immunity has been derived using a mechanism of ground potential variations. The equivalent circuit representing ground elements as lumped constants enables us to predict the transient ground potential differences between PCB (Printed Circuit Board) ground planes connected via signal cables and induced noise voltage at the receiving end. The calculation shows that the contribution of ground potential differences to noise voltage is comparable to that of the electromagnetic coupling between the discharge current on the enclosure and the circuit loops. The calculation also shows some characteristic results, such as; the induced noise voltage is remarkably dependent on the unbalance in ground cable lengths and on the impedance of ground conductors connecting PCBs, especially when the equipment uses a single-point grounding system. These characteristics were confirmed by measurements of induced ground potential differences, noise voltage and immunity levels. Thus the proposed method is shown to be very effective to analyze the dependency of grounding conditions on ESD immunity and to improve ESD immunity in equipment design.

Induced noises from breaking contact arc discharge and sliding contact discharge of dc motor are measured by pick up coil and current probe. Statistical properties, amplitude distribution probability (APD), of induced noise waveform are analyzed by simple method using intermediate frequency of spectrum analyzer. It is shown that APD characteristics can be used to estimate statistical characteristics and peak value of induced noise. Simulation model of the noise made by the combination of Gaussian noise is mentioned. The model called the composite noise generator (CNG) can be good fit to the real characteristics of both noises from breaking arc and dc motor. Applications of the CNG for noise filter using toroidal coil shows that the CNG is useful to realize the test of noise suppression characteristics. What parameters of the CNG should be considered is described for further applications.