This paper proposes a combination of novel Received Response (RR) sequence at the transmitter and a Matched Filter-RAKE (MF-RAKE) combining scheme receiver system for the Direct Sequence-Code Division Multiple Access Ultra Wideband (DS-CDMA UWB) multipath channel model. This paper also demonstrates the effectiveness of the RR sequence in Multiple Access Interference (MAI) reduction for the DS-CDMA UWB system. It suggests that by using conventional binary code sequence such as the M sequence or the Gold sequence, there is a possibility of generating extra MAI in the UWB system. Therefore, it is quite difficult to collect the energy efficiently although the RAKE reception method is applied at the receiver. The main purpose of the proposed system is to overcome the performance degradation for UWB transmission due to the occurrence of MAI during multiple accessing in the DS-CDMA UWB system. The proposed system improves the system performance by improving the RAKE reception performance using the RR sequence which can reduce the MAI effect significantly. Simulation results verify that significant improvement can be obtained by the proposed system in the UWB multipath channel models.

Spectral-amplitude coding (SAC) techniques in fiber-Bragg-grating (FBG)-based optical code-division multiple-access (OCDMA) systems were investigated in our previous work. This paper adopts the same network architecture to investigate the simultaneous reductions of multiple-access interference (MAI) and optical beat interference (OBI). The MAI is caused by overlapping wavelengths from undesired network coder/decoders (codecs) while the OBI is induced by interaction of simultaneous chips at adjacent gratings. It is proposed that MAI and OBI reductions may be obtained by use of: 1) a source spectrum that is divided into equal chip spacing; 2) coded FBGs characterized by approximately the same number of "0" and "1" code elements; and 3) spectrally balanced photo-detectors. With quasi-orthogonal Walsh-Hadamard coded FBGs, complementary spectral chips is employed as signal pairs to be recombined and detected in balanced photo-detectors, thus achieving simultaneous suppression of both MAIs and OBIs. Simulation results showed that the proposed OCDMA spectral-amplitude coding scheme achieves significant MAI and OBI reductions.

An optical spectral coding scheme is devised for fiber-optic code-division multiple-access (FO-CDMA) networks. The spectral coding is based on the pseudo-orthogonality of FO-CDMA codes properly written in the fiber Bragg grating (FBG) devices. For an incoming broadband optical signal having spectral components equal to the designed Bragg wavelengths of the FBG, the spectral components will be reflected and spectrally coded with the written FO-CDMA address codes. Each spectral chip has different central wavelength and is distributed over the spectrum of the incoming light source. Maximal-length sequence codes (m-sequence codes) are chosen as the signature or address codes to exemplify the coding and correlation processes in the FO-CDMA system. By assigning the N cycle shifts of a single m-sequence code to N users, we get an FO-CDMA network that can theoretically support N simultaneous users. To overcome the limiting factor of multiple-access interference (MAI) on the performance of the FO-CDMA network, an FBG decoder is configured on the basis of orthogonal correlation functions of the adopted pseudo-orthogonal codes. An intended receiver user that operates on the defined orthogonal correlation functions will reject any interfering user and obtain quasi-orthogonality between the FO-CDMA users in the network. Practical limiting issues on networking performance, such as non-flattened source spectra, optical path delay, and asynchronous data accesses, are evaluated in terms of the bit-error-rate versus the number of active users. As expected, the bit-error-rate will increase with the number of active users. Increasing the flatness parameter of optical signal will lead to a lower average error probability, since we are working in a part of the more flattened optical spectrum. In contrast, reducing the encoded bandwidth will reduce the total received power, and this will necessitate higher resolution of fiber Bragg gratings.