This study proposes a novel method for evaluating the transmission characteristics of a three-phase filter using the “Fortescue-mode S-parameters,” which are S-parameters whose variables are transformed into symmetrical coordinates (i.e., zero-/positive-/negative-phase sequences). The behavior of the filter under three-phase current, including its non-symmetry, can be represented by these S-parameters, without regard to frequency. This paper also describes a methodology for creating modal equivalent circuits that reflect Fortescue-mode S-parameters allowing the effects of circuit components on filter characteristics to be estimated. Thus, this method is useful not only for the measurement and evaluation but also for the analysis and design of a three-phase filter. In addition, the physical interpretation of asymmetrical/symmetrical insertion losses and the conversion method based on Fortescue-mode S-parameters are clarified.

Induced noises from breaking contact arc discharge and sliding contact discharge of dc motor are measured by pick up coil and current probe. Statistical properties, amplitude distribution probability (APD), of induced noise waveform are analyzed by simple method using intermediate frequency of spectrum analyzer. It is shown that APD characteristics can be used to estimate statistical characteristics and peak value of induced noise. Simulation model of the noise made by the combination of Gaussian noise is mentioned. The model called the composite noise generator (CNG) can be good fit to the real characteristics of both noises from breaking arc and dc motor. Applications of the CNG for noise filter using toroidal coil shows that the CNG is useful to realize the test of noise suppression characteristics. What parameters of the CNG should be considered is described for further applications.