Wireless full duplex (FD) communication can double the point-to-point throughput. To fully realize the benefits of the FD technique in wireless local area networks (WLANs), it is important to design the medium access control (MAC) protocols for FD communications. In FD MAC protocols, when a node wins the channel contention and transmits a primary transmission, its destination node can start a secondary transmission triggered by the primary transmission. Each secondary transmitter transmits a data frame even if its backoff timer is not zero. However, the backoff scheme in the FD MAC protocols follows the conventional scheme based on the distributed coordination function (DCF). Therefore, the nodes with FD MAC initialize the contention window (CW) size to minimum CW (CWmin) after their successful secondary transmissions. Therefore, CW initialization in the FD MAC causes further collisions at stations (STAs), which degrades network throughput. This paper proposes a novel backoff scheme for FD MAC protocols. In the proposed scheme, the CW size and backoff timer are not initialized but kept the current value after secondary transmissions. The proposed scheme can mitigate frame collisions at STAs and increase FD-transmission opportunity in the network, and then enhance the throughput significantly. This paper presents comprehensive performance evaluation in simulations, including non-saturation and saturation conditions, and co-existence conditions with legacy half duplex (HD) STAs. For performance analysis, this paper establishes Markov-chain models for the proposed scheme. The analytical results show theoretically that the operation of the proposed scheme enhances network throughput. The simulation results and analytical results show the effectiveness of the proposed scheme.

Full duplex (FD) communication can potentially double the throughput of a point-to-point link in wireless communication. Additionally, FD communication can mitigate the hidden node collision problem. The MAC protocols for FD communications are classified into two types; synchronous FD MAC and asynchronous one. Though the synchronous FD MAC mitigates hidden node collisions by using control frame, overhead duration for each data frame transmission may be a bottleneck for the networks. On the other hand, the asynchronous FD MAC mitigates the hidden node collisions by FD communication. However, it wastes more time due to transmission failure than synchronous FD MAC. Clarifying the effect of two major FD MAC types on networks requires a quantitative evaluation of the effectiveness of these protocols in networks with hidden node collisions. This paper proposes performance analysis of FD MAC protocols for wireless local area networks with hidden node collisions. Through the proposed analytical model, the saturated throughputs in FD WLANs with both asynchronous and synchronous FD MAC for any number of STAs and any payload size can be obtained.

This paper presents a Multi-channel MAC protocol with channel grouping for multi-channel ad-hoc networks. The proposed protocol has both concepts of the multiple rendezvous and the single control channel protocols, which were proposed as a MAC protocol for multi-channel ad-hoc network without centralized stations. In the proposed protocol, all the channels are divided into some groups and each group has a control channel. Network nodes circulate among the groups and channel negotiations are carried out on a control channel of the group. By applying the channel grouping, it is possible to enhance network throughput without reducing the channel-usage probability. Because there is an optimum group number for obtaining the highest throughput, this paper gives analytical expressions of maximum network throughput for the proposed protocol as a function of system parameters. The effectiveness of the proposed protocol is shown from simulation results. In addition, the validity of the analytical expressions is confirmed from quantitative agreements between analytical predictions and simulation results.

This work addresses the problem of a fast packet retransmission scheme intended for transporting delay-sensitive flows in a Cooperative Diversity (CD) environment. This cooperative fast retransmission scheme exploits the advantages of the CD environment and hybrid Automatic-Repeat-reQuest (ARQ), while allowing retransmission just one time via a cooperating user (i.e., partner) or via both the sender and the partner simultaneously. Complementary link packets are used for the retransmission whose policy can be adjusted on the basis of the qualities of channels among the sender, the partner and the receiver, as well as the application layer protocol data unit size, using the application throughput as the objective. For this scheme, we first derive the application throughput formulas which are then verified via simulations. Next, the CD-based optimized fast retransmission scheme is shown able to achieve better effective throughput (goodput) than other CD-based or non-CD-based ARQ schemes in various Nakagami-m slow-fading environments. As a result, the proposed scheme should be an excellent fast retransmission mechanism for real-time multimedia transport in many CD environments.

This paper quantitatively analyzes the maximum UDP (User Datagram Protocol) throughput for two-way flows in wireless string multi-hop networks. The validity of the analysis is shown by the comparison with the simulation and the experiment results. The authors also clarify the difference fundamental characteristics between a one-way flow and a two-way flow in detail based on the simulation results. The result shows that collisions at both ends' nodes are decisive in determining the throughput for two-way flows. The analyses are applicable to the estimation of VoIP (Voice over Internet Protocol) capacity for string multi-hop networks represented by WLAN (Wireless Local Area Network) mesh networks.

The performance of TCP data transmission deteriorates significantly when a TCP connection traverses a heterogeneous network consisting of wired and wireless links. This is mainly because of packet losses caused by the high bit error rate of wireless links. We proposed receiver-based ACK splitting mechanism in [1]. It is a new mechanism to improve the performance of TCP over wired and wireless heterogeneous networks. Our mechanism employs a receiver-based approach, which does not need modifications to be made to the sender TCP or the base station. It uses the ACK-splitting method for increasing the congestion window size quickly in order to restrain the throughput degradation caused by packet losses due to the high bit error rate of wireless links. In this paper, we develop a mathematical analysis method to derive the throughput of a TCP connection, with/without our mechanism, which traverses wired and wireless heterogeneous networks. By using the analysis results, we evaluate the effectiveness of our mechanism in the network where both of packet losses due to network congestion and those caused by the high bit error rate of wireless links take place. Through An evaluation of the proposed method shows that it can give a good estimation of TCP throughput under the mixture networks of wired/wireless links. We also find that the larger the bandwidth of the wireless link is, the more effective our mechanism becomes, therefore, the mechanism's usability will increase in the future as wireless networks become faster.

In this letter, performance evaluation of a system that combines between Code-Division Multiple Access (CDMA) and ALOHA protocol in multimedia networks is presented. In our analysis, we compare the performance between the two basic techniques of ALOHA protocol, i.e., Slotted-ALOHA (S-ALOHA) and Unslotted-ALOHA (U-ALOHA), when combined with CDMA scheme to support voice and data users operating in same CDMA channel. The quality of service (QoS) required for voice and data media is completely taken care of. We obtain the throughput of data media, and the outage probability for voice considering both voice and data offered loads. Throughput performance of S-ALOHA technique is almost twice of that of U-ALOHA. However, we show in this letter that when we combine CDMA with the two basic techniques of ALOHA to accomplish multimedia transmission, both techniques have almost same performance. And, thus, CDMA U-ALOHA can be a good candidate for multimedia networks.

We present a throughput analysis of a multi-address call extraction server in F-NET. The extraction server splits a multi-address call into individual calls. Since the actual operation mechanisms of the server are complicated, it is difficult to directly apply the standard Markov chain technique. Restricting ourselves to the case where the server is offered by a saturated input process, we propose a simple probabilistic method to investigate the departure process of the server and its asymptotic behavior. Numerical examples evaluated by the method are compared with simulations, which demonstrate the accuracy of our modeling approach.

An analytical framework to study the nonuniformity in geographical distribution of the traffic load in low earth orbit satellite communication systems is presented. The model is then used to evaluate the throughput performance of the system with direct-sequence packet spread-slotted ALOHA multiple-access technique. As the result, it is shown that nonuniformity in traffic makes the characteristics of the system significantly different from the results of uniform traffic case and that the performance of each user varies according to its location. Moreover, the interference reached from users of adjacent satellites is shown to be one of the main factors that limit the performance of system.

In this paper, a type hybrid ARQ scheme with Adaptive Forward Error Correction (ARQ/AFEC) using BCH codes is proposed and analyzed. The basic idea in the proposed type hybrid ARQ/AFEC scheme is to increase the error-correcting capability of BCH code according to channel state using incremental redundancy. The incremental redundancy is the remainder ai(x) of an information frame f(x) of length n divided by a minimum polynomial mi(x) of α2i-1, where α is a primitive element of finite field GF(2l). Let gi(x) be the product of mj(x) (j=1, 2, , i) and let ci(x) be the remainder of f(x) divided by gi(x). The polynomial ci(x) is obtained from the remainders ai(x) and ci-1(x) since mi(x)and gi-1 (x) are relatively prime. Since f(x) + ci(x) is divided by gi(x), f(x) + ci(x) is the codeword of an i-error-correcting BCH code when n2l-1. So, the errors less than or equal to i bits in f(x) can be corrected if ci(x) has no error.