Multi-FPGA systems, which consist of multiple FPGAs and a printed circuit board connecting them, are useful and important tools for prototyping large scale circuits, including SoCs. In this paper, we propose a method for optimizing inter-FPGA signal transmission to accelerate the system frequency of multi-FPGA prototyping systems and shorten prototyping time. Compared with the number of I/O pins of an FPGA, the number of I/O signals between FPGAs usually becomes very large. Thus, time-multiplexed I/Os are used to resolve the problem. On the other hand, they introduce large delays to inter-FPGA I/O signals, and much lower the system frequency. To reduce the degradation of the system frequency, we have proposed a method for optimally selecting signals to be time-multiplexed and signals not to be time-multiplexed. However, this method assumes that there exist physical connections (i.e., wires on the printed circuit board) between every pair of FPGAs, and cannot handle I/O signals between a pair of FPGAs that have no physical connections between them. Thus, in this paper, we propose a method for obtaining indirect inter-FPGA routes for such I/O signals, and then combine the indirect routing method and the time-multiplexed signal selection method to realize effective time-multiplexing of inter-FPGA I/O signals on systems with various topologies.

In multi-FPGA prototyping systems for circuit verification, serialized time-multiplexed I/O technique is used because of the limited number of I/O pins of an FPGA. The verification time depends on a selection of inter-FPGA signals to be time-multiplexed. In this paper, we propose a method that minimizes the verification time of multi-FPGA systems by finding an optimal selection of inter-FPGA signals to be time-multiplexed. In the experiments, it is shown that the estimated verification time is improved 38.2% on average compared with conventional methods.

Lately, time-multiplexed I/Os for multi-device implementations (e.g., multi-FPGA systems), have come into practical use. They realize multiple I/O signal transmissions between two devices in one system clock cycle using one I/O wire between the devices and multiple I/O clock cycles. Though they ease the limitation of the number of I/O-pins of each device, the system clock period becomes much longer approximately in proprotion to the maximum number of multiplexed I/Os on a signal path. There is no conventional partitioning algorithm considering the effect of time-multiplexed I/Os directly. We introduce a new cost function for evaluating the suitability of a bipartition for multi-device implementations with time-multiplexed I/Os. We propose a performance-driven bipartitioning method VIOP which minimizes the value of the cost function. Our method VIOP combines three algorithms, such that i) min-cut partitioning, ii) coarse performance-driven partitioning, iii) fine performance-driven partitioning. For min-cut partitioning and coarse performance-driven partitioning, we employ a well-known conventional bipartitioning algorithms CLIP-FM and DUBA, respectively. For fine performance-driven partitioning for the final improvement of a partition, we propose a partitioning algorithm CAVP. By our method VIOP, the average cost was improved by 10.4% compared with the well-known algorithms.