This brief paper proposes a dual-wideband filter consisting of a parallel-coupled stepped-impedance-resonator (SIR) and open-circuited stubs. Firstly, a notched UWB (ultra-wideband) bandpass filter (BPF) with steep skirt characteristics is theoretically designed. Then a bandstop filter(BSF) is implemented using an SIR and open stubs. By replacing the transmission line part of UWB filter with the BSF, a novel dual-wideband filter (DWBPF) is realized. As a design example, a DWBPF with two passbands, i.e. 3.4-4.8GHz and 7.25-10.25GHz, is designed to validate the design procedure. The designed filter exhibits steep skirt characteristics.

To implement a wideband bandpass filter with improved skirt-selectivity and out-band characteristics, a new parallel-coupled three-line unit with two short-circuited stubs symmetrically-loaded at the center line is proposed. Unlike most traditional ones, the passband of the proposed parallel-coupled three-line structure is based on the cross-coupling between non-adjacent lines rather than the direct-coupling between adjacent ones, whereas a pair of attenuation poles is found in the stopbands. After revealing its work mechanism, an efficient filter-design-scheme is correspondingly proposed for the presented structure. Firstly, based on a chebyshev-filter synthesis theory, a wideband passband filter consisting of a parallel-coupled two-line and two short-circuited stubs loaded at the input- and output- ports is designed. Furthermore, by putting a properly-designed 3/4-wavelength stepped-impedance resonator (SIR) in between the parallel-coupled two lines, two attenuation poles are then realized at the frequencies very close to the cutoff ones. Accordingly, the roll-off characteristics of the filter are significantly-improved to greater than 100,dB/GHz. Furthermore, two-section open-ended stubs are used to replace the short-circuited ones to realize a pair of extra attenuation poles in stopbands. To validate the proposed techniques, a wideband filter with a bandwidth of 3--5,GHz (Fractional bandwidth (FBW) $= (5,GHz-3,GHz)/4,GHz =50%)$ was designed, simulated, fabricated and measured. The measured responses of the filter agree well with the simulation and theoretical ones, which validates the effectiveness of the newly-proposed three-line unit and the corresponding design scheme.

A low-loss ultra-wide band (UWB) filter is presented, which uses miniaturized parallel coupled line along with an standard printed circuit board (PCB) technology. By analyzing even- and odd-mode impedances (in comparison with conventional parallel coupled lines) of miniaturized parallel coupled line, this structure provides tight coupling, thus, relaxing the requirements on physical dimensions width and spacing when designing broadband filters. A bandpass filter for Mode 1 (the first 3 sub-bands) in the 3.1-5 GHz band for Multi-Band Orthogonal Frequency Division Multiplexing (MB-OFDM) UWB is realized and compared with a conventional parallel coupled line filter. The experimental results show as much as 0.9 dB insertion loss improvement over the conventional counterpart.

This paper presents the ultrawideband filters for UWB fullband (range of 3.1-10.6 GHz) applications. This filter consists of ring filter for wide-bandwidth and coupled line structure for suppressing unwanted passband in upper and lower stopbands. Especially, the filter structure was realized on silicon substrate using thin film technology, adequate for wafer level packaging, which can be integrated with CMOS UWB chipset that is currently on development. To minimize the dimension of the filter, the Hilbert structure was applied in ring filter and the meander shaped broadside coupled structure was also adopted in the coupled line structure. The size of the fully realized filter structure is 4.43.6 mm2. The insertion loss in passband is 1.5 dB and the return loss is larger than 15 dB, respectively. The group delay in center frequency is 0.2 ns and the group delay variation is less than 0.15 ns.