Non-volatile memory (NVM) is a promising technology for low-energy and high-capacity main memory of computers. The characteristics of NVM devices, however, tend to be fundamentally different from those of DRAM (i.e., the memory device currently used for main memory), because of differences in principles of memory cells. Typically, the write latency of an NVM device such as PCM and ReRAM is much higher than its read latency. The asymmetry in read/write latencies likely affects the performance of applications significantly. For analyzing behavior of applications running on NVM-based main memory, most researchers use software-based emulation tools due to the limited number of commercial NVM products. However, these existing emulation tools are too slow to emulate a large-scale, realistic workload or too simplistic to investigate the details of application behavior on NVM with asymmetric read/write latencies. This paper therefore proposes a new NVM emulation mechanism that is not only light-weight but also aware of a read/write latency gap in NVM-based main memory. We implemented the prototype of the proposed mechanism for the Intel CPU processors of the Haswell architecture. We also evaluated its accuracy and performed case studies for practical benchmarks. The results showed that our prototype accurately emulated write-latencies of NVM-based main memory: it emulated the NVM write latencies in a range from 200 ns to 1000 ns with negligible errors from 0.2% to 1.1%. We confirmed that the use of our emulator enabled us to successfully estimate performance of practical workloads for NVM-based main memory, while an existing light-weight emulation model misestimated.

Fine-grained power gating (FGPG) is a power-saving technique by switching off circuit blocks while the blocks are idle. Although FGPG can reduce power consumption without compromising computational performance, switching the power supply on and off causes energy overhead. To prevent power increase caused by the energy overhead, in our prior research we proposed an FGPG control method of the operating system(OS) based on pre-analyzing applications' power usage. However, modern computing systems have a wide variety of use cases and run many types of application; this makes it difficult to analyze the behavior of all these applications in advance. This paper therefore proposes a new FGPG control method without profiling application programs in advance. In the new proposed method, the OS monitors a circuit's idle interval periodically while application programs are running. The OS enables FGPG only if the interval time is long enough to reduce the power consumption. The experimental results in this paper show that the proposed method reduces power consumption by 9.8% on average and up to 17.2% at 25°C. The results also show that the proposed method achieves almost the same power-saving efficiency as the previous profile-based method.

The authors have been researching on reducing the power consumption of microprocessors, and developed a low-power processor called “Geyser” by applying power gating (PG) function to the individual functional units of the processor. PG function on Geyser reduces the power consumption of functional units by shutting off the power voltage of idle units. However, the energy overhead of switching the supply voltage for units on and off causes power increases. The amount of the energy overhead varies with the behavior of each functional unit which is influenced by running application, and also with the core temperature. It is therefore necessary to switch the PG function itself on or off according to the state of the processor at runtime to reduce power consumption more effectively. In this paper, the authors propose a PG control method to take the power overhead into account by the operating system (OS). In the proposed method, for achieving much power reduction, the OS calculates the power consumption of each functional unit periodically and inhibits the PG function of the unit whose energy overhead is judged too high. The method was implemented in the Linux process scheduler and evaluated. The results show that the average power consumption of the functional units is reduced by up to 17.2%.