The authors have been researching on reducing the power consumption of microprocessors, and developed a low-power processor called “Geyser” by applying power gating (PG) function to the individual functional units of the processor. PG function on Geyser reduces the power consumption of functional units by shutting off the power voltage of idle units. However, the energy overhead of switching the supply voltage for units on and off causes power increases. The amount of the energy overhead varies with the behavior of each functional unit which is influenced by running application, and also with the core temperature. It is therefore necessary to switch the PG function itself on or off according to the state of the processor at runtime to reduce power consumption more effectively. In this paper, the authors propose a PG control method to take the power overhead into account by the operating system (OS). In the proposed method, for achieving much power reduction, the OS calculates the power consumption of each functional unit periodically and inhibits the PG function of the unit whose energy overhead is judged too high. The method was implemented in the Linux process scheduler and evaluated. The results show that the average power consumption of the functional units is reduced by up to 17.2%.

Fine-grained power gating (FGPG) is a power-saving technique by switching off circuit blocks while the blocks are idle. Although FGPG can reduce power consumption without compromising computational performance, switching the power supply on and off causes energy overhead. To prevent power increase caused by the energy overhead, in our prior research we proposed an FGPG control method of the operating system(OS) based on pre-analyzing applications' power usage. However, modern computing systems have a wide variety of use cases and run many types of application; this makes it difficult to analyze the behavior of all these applications in advance. This paper therefore proposes a new FGPG control method without profiling application programs in advance. In the new proposed method, the OS monitors a circuit's idle interval periodically while application programs are running. The OS enables FGPG only if the interval time is long enough to reduce the power consumption. The experimental results in this paper show that the proposed method reduces power consumption by 9.8% on average and up to 17.2% at 25°C. The results also show that the proposed method achieves almost the same power-saving efficiency as the previous profile-based method.