Circuit simulators are used to verify circuit functionality and to obtain detailed timing information before the expensive fabrication process takes place. They have become an essential CAD tool in an era of sub-micron technology. We have developed a new event-driven MOS circuit simulator to replace a direct method circuit simulator. In our simulator, partitioned subcircuits are analyzed by a direct method matrix solver, and these are controlled by an event-driven scheme to maintain accuracy. The key of this approach is how to manage events for circuit simulation. We introduced two types of events: self-control events for a subcircuit and prediction correcting events between subcircuits. They control simulation accuracy, and bring simulation efficiency through multi-rate behavior of a large scale circuit. The event-driven scheme also brings some useful functions which are not available from a direct method circuit simulator, such as a selected block simulation function and a batch simulation function for load variation. We simulated logic modules (buffer, adder, and counter) with about 1000 MOSFETs with our event-driven MOS circuit simulator. Our simulator was 5-7 times faster than a SPICE-like circuit simulator, while maintaining the less than 1% error accuracy. The selected block simulation function enables to shorten simulation time without losing any accuracy by selecting valid blocks in a circuit to simulate specified node waveforms. Using this function, the logic modules were simulated 13-28 times faster than the SPICE-like circuit simulator while maintaining the same accuracy.

We have studied a circuit partitioning approach in the view of parallel circuit simulation on a MIMD parallel computer. In parallel circuit simulation, a circuit is partitioned into equally sized subcircuits while minimizing the number of interconnection nodes. Besides circuit partitioning time should be short enough compared with the total simulation time. From the details of circuit simulation time, we found that balancing subcircuits is critical for low parallel processing, whereas minimizing the interconnection nodes is critical for highly parallel processing. Our circuit partitioning approach consists of four steps： Grouping transistors, initial partitioning the transistor-groups, minimizing the number of interconnection nodes, and balancing the subcircuits. It is based on an algorithmic approach, and can directly control the tradeoffs between balancing subcircuits and minimizing the interconnection nodes by adjusting the parameters. We partitioned a test circuit with 3277 transistors into 4, 9, ... , 64 subcircuits, and did parallel simulations using PARACS, our parallel circuit simulator, on an AP1000 parallel computer. The circuit partitioning time was short enough-less than 3 percent of the total simulation time. The highest performance of parallel analysis using 49 processors was 16 times that of a single processor, and that for total simulation was 9 times.