We are developing a superconducting analog-to-digital converter (ADC) as a readout for high-resolution X-ray detectors based on a superconducting tunnel junction (STJ). The ADC has a sensitive front end which consists of a DC superconducting quantum interference device (SQUID). A signal current is digitized by this front end without using any preamplifiers. A single-flux-quantum (SFQ) pulse train whose frequency is proportional to the input current is launched by the front end, and integrated by a digital counter. The counter has a 10-bit resolution, and the integrated value is scanned and transferred to room-temperature processing modules with a frequency of 40 MHz. In this paper, the design of the ADC is described, and the preliminary results of the ADC performance test are shown. The performance of the STJ accompanied by the ADC is discussed in terms of the X-ray energy resolution.

Present status of the development of superconducting tunnel junctions for the detection of X-ray photons and heavy ions is reported. The energy resolution for 5.9 keV X-rays was measured to be 41 eV, 58 eV, 65 eV and 129 eV with STJs of 2020 µm2, 100100 µm2, 200200 µm2 and 500500 µm2, respectively, and a model to describe the phonon-mediated X-ray signals is discussed. Direct voltage switching induced by heavy ions was successfully observed.

A normal-distribution-function-shaped superconducting tunnel junction (NDF-STJ) which consists of Nb/Al-AlOx/Al/Nb has been fabricated as an X-ray detector. Current - voltage characteristics were measured at 0.4 K using three kinds of STJs, which have the dispersion parameters σ of 0.25, 0.45 and 0.75. These STJs showed very low subgap leakage current of about 5 nA. By irradiating with 5.9 keV X-rays, we obtained the spectrum of these NDF-STJs. They showed good energy resolution with small magnetic fields of below 3 mT, which is about one-tenth of those for conventional-shaped STJs.