This paper reviews the evolutionary process that reduced the transmission loss of silica optical fibers from the report of 20dB/km by Corning in 1970 to the current record-low loss. At an early stage, the main effort was to remove impurities especially hydroxy groups for fibers with GeO2-SiO2 core, resulting in the loss of 0.20dB/km in 1980. In order to suppress Rayleigh scattering due to composition fluctuation, pure-silica-core fibers were developed, and the loss of 0.154dB/km was achieved in 1986. As the residual main factor of the loss, Rayleigh scattering due to density fluctuation was actively investigated by utilizing IR and Raman spectroscopy in the 1990s and early 2000s. Now, ultra-low-loss fibers with the loss of 0.150dB/km are commercially available in trans-oceanic submarine cable systems.

By optimizing the structure of erbium-doped fibers, high efficiency such as a gain coefficient of 6.3dB/mW, or a slope efficiency of 92.6% have been realized with very flat wavelength dependence. Though the optimized structure has high NA, the splice loss with standard fibers can be lowered by the additional arc technique. The carbon coated fiber with a fatigue parameter over 150 guarantees the reliability, even when wounded on a small coil. In-line isolators and WDM couplers have been also developed. An amplifier module has been assembled, resulting in an output power more than +16dBm owing to the high performance of each component.

A fiber Bragg grating, which has periodical perturbation of the refractive index in the fiber core, acts as a wavelength selective reflection filter and steep optical spectrum can be realized by forming more than ten thousand of gratings along the fiber core. Owing to capability of making steep optical spectrum, fiber Bragg gratings has been expected to be introduced practical use as multiplexing or demultiplexing filters in dense WDM transmission systems. On the other hand, radiation mode loss, reflection side mode and temperature dependence of Bragg wavelength, should be improved to put the fiber Bragg grating to practical use in dense WDM transmission systems. In this paper, an optimum design and performance of the fiber Bragg grating for dense WDM systems are described. The photosensitive cladding fiber realized less than 0. 2 dB insertion loss at transmitted signal channels and less than 0. 1 dB splicing loss with standard single-mode fibers. An adequate apodization technique in the refractive index distribution suppressed reflection side modes. A temperature compensating package, which gives longitudinal strain with negative temperature dependence to a fiber Bragg grating, minimized temperature dependence of Bragg wavelength less than 0. 001 nm/. Thermal decay of Bragg grating was also investigated and adequate annealing condition was estimated to obtain sufficient stability for practical use in dense WDM transmission.