Novel, very small-size multilayer MMIC's using miniature microstrip lines on a thin dielectric film, as well as the features of the multilayer structure, are presented. Very narrow-width thin-film transmission lines, meander-like configurations, line crossovers, and vertical connections, which are effective for significant chip-size reduction and flexible layout, are realized and utilized in a 2.5-3 µmN-layer dielectric film structure. 180-degree and 90-degree hybrids and umltiport Wilkinson dividers, which are implemented in small areas of 0.1 mm2 and 1.7 mm2, are presented. Furthermore, layout flexibility in the multilayer structure is demonstrated by implementing distributed amplifiers into the layers.

This paper presents a wide-input-voltage-range and high-efficiency boost converter that is assisted by a transformer-based oscillator. The oscillator can provide a sufficient amount of power to drive a following switched-inductor boost converter at low voltages. Moreover, it adopts a novel amplitude-regulation circuit (ARC) without using high power-consuming protective devices to suppress the expansion of the oscillation amplitude at high input voltages. Therefore, it can avoid over-voltage problems without sacrificing the power efficiency. Additionally, a power-down circuit (PDC) is implemented to turn off the oscillator, when the boost converter can be driven by its own output power, thus, eliminating the power consumption by the oscillator and improving the power efficiency. We implemented the ARC and the PDC with discrete components rather than one-chip integration for the proof of concept. The experimental results showed that the proposed circuit became possible to operate from an input voltage of 60mV to 3V while maintaining high peak efficiency up to 92%. To the best of our knowledge, this converter provides a wider input range in comparison with the previously-published converters. We are convinced that the proposed approach by inserting an appropriate start-up circuit in a commercial converter will be effective for rapid design proposals in order to respond promptly to customer needs as Internet of things (IoT) devices with energy harvester.

This paper presents a thin, compact beacon transmitter operating without needing battery replacement by using a photovoltaic (PV) film harvester. The beacon is formed of a power-control circuit (PCC) that can monitor small amounts of power from the harvester and properly control mode switching at low-power consumption. This leads to the realization of a maintenance-free beacon requiring no battery replacement. The beacon prototype is 55×20×2 mm in size and has a PV cell of 3 cm2. It allows a start-up operation from just 44-lux illuminance. The PV area required for the operation can be 1.7 times smaller than that of conventional beacons, thanks to the current saving with appropriate sequential control of the PCC. Since the beacon makes operation possible in emergency stairs, underground passages and other dark places, the application field for Internet of things (IoT) services can be expanded. Furthermore, a beacon equipped with a secondary battery (BSB: Beacon with Secondary Battery) can be configured by adding a charge-discharge power monitoring circuit. The BSB transmits an advertising packet during the daytime while charging surplus power, and works using the stored power during the night; this results in a continuous operation for one week with one transmission every 3 seconds even at 0-lux illuminance. Without developing a new radiofrequency chip or module, commercial low-power devices can be easily adjusted depending on the application by adding appropriate power-control circuits. We are convinced that this design scheme will be effective as a rapid design proposal for IoT services.