1-6hit |
Masayuki KAWATA Kiichi TATEISHI Kenichi HIGUCHI
This paper investigates the performance of interleave division multiple access (IDMA)-based random access with various interference canceller structures in order to support massive machine-type communications (mMTC) in the fifth generation (5G) mobile communication system. To support massive connectivity in the uplink, a grant-free and contention-based multiple access scheme is essential to reduce the control signaling overhead and transmission latency. To suppress the packet loss due to collision and to achieve multi-packet reception, non-orthogonal multiple access (NOMA) with interference cancellation at the base station receiver is essential. We use IDMA and compare various interference canceller structures such as the parallel interference canceller (PIC), successive interference canceller (SIC), and their hybrid from the viewpoints of the error rate and decoding delay time. Based on extensive computer simulations, we show that IDMA-based random access is a promising scheme for supporting mMTC and the PIC-SIC hybrid achieves a good tradeoff between the error rate and decoding delay time.
Daisuke KURITA Kiichi TATEISHI Daisuke KITAYAMA Atsushi HARADA Yoshihisa KISHIYAMA Hideshi MURAI Shoji ITOH Arne SIMONSSON Peter ÖKVIST
This paper evaluates a variety of key 5G technologies such as base station (BS) massive multiple-input multiple-output (MIMO) antennas, beamforming and tracking, intra-baseband unit (BBU) hand over (HO), and coverage. This is done in different interesting 5G areas with a variety of radio conditions such as an indoor office building lobby, an outdoor parking area, and a realistic urban deployment of a 5G radio access system with BSs installed in buildings to deploy a 5G trial area in the Tokyo Odaiba waterfront area. Experimental results show that throughput exceeding 10Gbps is achieved in a 730MHz bandwidth using 8 component carriers, and distributed MIMO throughput gain is achieved in various transmission point deployments in the indoor office building lobby and outdoor parking area using two radio units (RUs). In particular, in the outdoor parking area, a distinct advantage from distributed MIMO is expected and the distributed MIMO gain in throughput of 60% is achieved. The experimental results also clarify the downlink performance in an urban deployment. The experimental results show that throughput exceeding 1.5Gbps is achieved in the area and approximately 200 Mbps is achieved at 500m away from the BS. We also confirm that the beam tracking and intra-BBU HO work well compensating for high path loss at 28-GHz, and achieve coverage 500m from the BS. On the other hand, line of sight (LoS) and non-line-of sight (N-LoS) conditions are critical to 5G performance in the 28-GHz band, and we observe that 5G connections are sometimes dropped behind trees, buildings, and under footbridges.
Kiichi TATEISHI Daisuke KURITA Atsushi HARADA Yoshihisa KISHIYAMA Takehiro NAKAMURA Stefan PARKVALL Erik DAHLMAN Johan FURUSKOG
This paper presents indoor and outdoor experiments that confirm 4-Gbps throughput based on 400-MHz bandwidth transmission when applying carrier aggregation (CA) with 4 component carriers (CCs) and 4-by-4 single-user multiple-in multiple-out multiplexing (MIMO) in the 15-GHz frequency band in the downlink of 5G cellular radio access. A new radio interface with time division duplexing (TDD) and radio access based on orthogonal frequency-division multiple access (OFDMA) is implemented in a 5G testbed to confirm ultra-high speed transmission with low latency. The indoor experiment in an entrance hall shows that the peak throughput is 4.3Gbps in front of the base station (BS) antenna where the reference signal received power (RSRP) is -40dBm although the channel correlation at user equipment (UE) antenna is 0.8. The outdoor experiment in an open-space parking area shows that the peak throughput is 2.8Gbps in front of a BS antenna with a high RSRP although rank 2 is selected due to the high channel correlation. The results also show that the average throughput of 2Gbps is achieved 120m from the BS antenna. In a courtyard enclosed by building walls, 3.6Gbps is achieved in an outdoor-to-outdoor environment with a high RSRP and in an outdoor-to-indoor environment where the RSRP is lower due to the penetration loss of glass windows, but the multipath rich environment contributes to realizing the low channel correlation.
Daisuke KITAYAMA Kiichi TATEISHI Daisuke KURITA Atsushi HARADA Minoru INOMATA Tetsuro IMAI Yoshihisa KISHIYAMA Hideshi MURAI Shoji ITOH Arne SIMONSSON Peter ÖKVIST
This paper describes the results of outdoor mobility measurements and high-speed vehicle tests that clarify the 4-by-8 multiple-input multiple-output (MIMO) throughput performance when applying distributed MIMO with narrow antenna-beam tracking in a 28-GHz frequency band in the downlink of a 5G cellular radio access system. To clarify suitable transmission point (TP) deployment for mobile stations (MS) moving at high speed, we examine two arrangements for 3TPs. The first sets all TPs in a line along the same side of the path traversed by the MS, and the other sets one TP on the other side of the path. The experiments in which the MS is installed on a moving wagon reveal that the latter deployment case enables a high peak data rate and high average throughput performance exhibiting the peak throughput of 15Gbps at the vehicle speed of 3km/h. Setting the MS in a vehicle travelling at 30km/h yielded the peak throughput of 13Gbps. The peak throughput of 11Gbps is achieved at the vehicle speed of 100km/h, and beam tracking and intra-baseband unit hand over operation are successfully demonstrated even at this high vehicle speed.
Kiichi TATEISHI Kenichi HIGUCHI
This paper presents an adaptive amplify-and-forward (AF)-type relay method appropriate for the cellular downlink. The proposed method adaptively selects active relay stations (RSs) based on the path loss between each set of user equipment (UE) and the base station (BS) and that between each RS in order to avoid unnecessary enhancement of inter-cell interference and bandwidth reduction due to transmission relay. Furthermore, to enhance the spectrum efficiency under relay transmission, the frequency used for the relay transmission from the RS to the cell-edge user is reused for the direct transmission from the BS to the cell-center user. Based on computer simulations, the system-level average throughput and cell-edge user throughput of the proposed method are compared to those for cases using no relaying or a conventional repeater. The simulation results show the effectiveness of the proposed method.
Daisuke KURITA Kiichi TATEISHI Atsushi HARADA Yoshihisa KISHIYAMA Takehiro NAKAMURA Stefan PARKVALL Erik DAHLMAN Johan FURUSKOG
This paper presents outdoor field experimental results to clarify the 4-by-4 multiple-input multiple-output (MIMO) throughput performance when applying joint transmission (JT) and distributed MIMO to the 15-GHz frequency band in the downlink of a 5G cellular radio access system. Experimental results for JT in a 100m × 70m large-cell scenario show that throughput improvement of up to 10% is achieved in most of the area and the peak data rate is improved from 2.8Gbps to 3.7Gbps. Based on analysis of the reference signal received power (RSRP) and channel correlation, we find that the RSRP is improved in lower RSRP areas, and that the channel correlation is improved in higher RSRP areas. These improvements contribute to higher throughput performance. The advantage of distributed MIMO and JT are compared in a 20m × 20m small-cell scenario. The throughput improvement of 70% and throughput exceeding 5 Gbps were achieved when applying distributed MIMO due to the improvement in the channel correlation. When applying JT, the RSRP is improved; however the channel correlation is not. As a result, there is no improvement in the throughput performance in the area. Finally, the relationship between the transmission point (TP) allocation and the direction of user equipment (UE) antenna arrangement is investigated. Two TP positions at 90 and 180deg. from each other are shown to be advantageous in terms of the throughput performance with different direction of UE antenna arrangement. Thus, we conclude that JT and distributed MIMO are promising technologies for the 5G radio access system that can compensate for the propagation loss and channel correlation in high frequency bands.