Shift margins in down and cross track directions and skew angle were investigated using micromagnetic simulation with a shielded planar head for patterned media with an areal density of 1 Tbit/in2. The shift margins were quantitatively estimated using parameters of the head field and the magnetic properties of media. It is essential to use a head with a higher field gradient and a medium with a small field width between saturation and nucleation fields, to obtain a larger down track shift margin, and a head with a narrower cross track field distribution to obtain a larger cross track shift margin and skew angle margin.

Pole-tip-driven structure, which is composed of a coil wounded at the main pole tip, is favorable for obtaining a sharp and strong head field as a single-pole-type head. Three kinds of pole-tip-driven-type heads with different yoke and coil structures are investigated in terms of magnetomotive force dependence of head field and effect of coil recession. Field calculation by finite-element method (FEM) showed that the three heads exhibited the same field sensitivity in spite of the difference in distribution of coil exciting field and magnetization of the main pole. In a lower range of magnetomotive force the heads showed different dependence of field sensitivity on the coil recession. However, there was not much difference in degradation of sensitivity in a region near the saturation of field. Thus, the importance of reducing coil recession was confirmed as reported earlier.

To develop ultra high density magnetic recording systems, a quasi-static system with a reciprocating medium motion against a stand still head was developed for a read/write tester. Double-layered perpendicular recording media and merged GMR heads assembled on a conventional head-gimbal assembly (HGA) were applied to evaluate the read/write performances. A smooth sliding contact motion was achieved, however, the head-to-medium spacing was varied depending on the head motion direction. The spacing in the reverse running direction of the conventional head slider seems to be smaller than that of the flying height in a high-speed spin stand. A merged ring head was suitable for perpendicular magnetic recording in the case of the reverse direction sliding.