This paper investigates the interference suppression effect from much higher rate dedicated physical channels (DPCHs) of a parallel-type coherent multistage interference canceller (COMSIC) with iterative channel estimation (ICE) by laboratory experiments in the transmit-power-controlled W-CDMA reverse link. The experimental results elucidate that when two interfering DPCHs exist with the spreading factor (SF) of 8 and with the ratio of the target signal energy per bit-to-interference power spectrum density ratio (Eb/I0) of fast transmit power control, ΔEb/I0, of -6 dB (which corresponds to 64 simultaneous DPCHs with SF = 64, i.e., the same symbol rate as the desired DPCH), the implemented COMSIC receiver with ICE exhibits a significant decrease in the required transmit signal energy per bit-to-background noise power spectrum density ratio (Eb/N0) at the average bit error rate (BER) of 10-3 (while the matched filter (MF)-based Rake receiver could not realize the average BER of 10-3 due to severe multiple access interference (MAI)). It is also found that the achieved BER performance at the average BER of 10-3 of the COMSIC receiver with the A/D converter quantization of 8 bits in the laboratory experiments is degraded by approximately 1.0 dB and 4.0 dB compared to the computer simulation results, when ΔEb/I0=-6 dB and -9 dB, respectively, due to the quantization error of the desired signal and path search error for the Rake combiner. Finally, we show that the required transmit Eb/N0 at the average BER of 10-3 of the third-stage COMSIC with ICE is decreased by approximately 0.3 and 0.5 dB compared to that of COMSIC with decision-feedback type channel estimation (DFCE) with and without antenna diversity reception, respectively.

This paper presents the results of field experiments on the pilot symbol assisted (PSA) coherent multistage interference canceller (COMSIC) receiver in the direct sequence code division multiple access (DS-CDMA) reverse link. The implemented COMSIC receiver comprising three cancellation stages employs PSA channel estimation and replica generation of multiple access interference (MAI) of other users. The experimental results demonstrate that the COMSIC receiver associated with antenna diversity reception and fast transmission power control (TPC) exhibits effectiveness in suppressing severe MAI in actual multipath fading channels. The transmission power of a mobile station (MS) when the COMSIC receiver is employed at a base station (BS) is reduced by approximately 2.0 and 4.0 dB compared to that with the matched filter (MF)-based Rake receiver when the ratios of the target signal energy per bit-to-interference power spectrum density ratio (Eb/I0) of the desired user to the target user are Δtarget= -6 and -9 dB, respectively. Furthermore, for the COMSIC receiver, the transmission power of a MS at the average bit error rate (BER) of 10-3 with antenna diversity is decreased by approximately 7.5 and 11 dB compared to that without antenna diversity when the Δtarget values are -6 and -9 dB, respectively.

Experimental results of 1. 92 Mbps data transmission over a 20 MHz wideband DS-CDMA (W-CDMA) mobile radio link under frequency selective multipath fading are presented. 1. 92 Mbps data were transmitted using an orthogonal multicode transmission scheme. The combined use of antenna diversity reception, RAKE combining, and concatenated channel coding is applied to improve transmission performance. Laboratory and field experimental results demonstrated the possibility of 2 Mbps data transmission in a real fading environment.

This paper experimentally evaluates the bit error rate (BER) performance of single-carrier broadband DS-CDMA (B-CDMA) scheme using a 100-MHz bandwidth (chip rate of 81.92 Mcps) in frequency-selective multipath fading channels. The achievable information bit rate is 20.36 (2.5) Mbps when the spreading factor (SF) is SF = 4 (32). In order to achieve a high data-rate transmission with high quality (i.e., average BER is below 10-6), we apply pilot symbol-assisted coherent Rake receiving with a large number of Rake fingers (maximum number of Rake fingers is SF2), 2-branch antenna diversity reception, convolutional coding, and signal-to-interference power ratio (SIR) measurement-based fast closed-loop transmit power control (TPC). Experimental results show that the average BER of 10-6 for the 20.36 (2.5)-Mbps transmission is achieved at the required average transmit Eb/N0 of approximately 6.7 (5.0) dB when the number of multipaths is L = 2 and the maximum fading Doppler frequency is fD = 20 Hz. We also show that Rake time diversity and fast TPC are effective in a broadband propagation channel where many resolvable paths (such as 12 paths) are observed.

In order to increase the link capacity in the wideband direct sequence code division multiple access (W-CDMA) reverse link, employing a parallel-type coherent multi-stage interference canceller (COMSIC) is more practical than employing a serial (successive)-type due to its inherent advantage of a short processing delay, although its interference suppression effect is inferior to that of the serial-type. Therefore, this paper proposes a parallel-type COMSIC with iterative channel estimation (ICE) using both pilot and decision-feedback data symbols at each canceling stage in order to improve the interference suppression effect of the parallel-type COMSIC. Computer simulation results demonstrate that by applying the parallel-type COMSIC with ICE after FEC decoding, the capacity in an isolated cell can be increased by approximately 1.6 (2.5) times that of the conventional parallel-type COMSIC with channel estimation using only pilot symbols (the MF-based Rake receiver) at the required average transmit Eb/N0 of 15 dB, i.e. in the interference-limited channel. The results also show that, although the capacity in the isolated cell with the parallel-type COMSIC with ICE after FEC decoding is degraded by approximately 6% compared to that with the serial-type COMSIC with ICE after FEC decoding, the processing delay can be significantly decreased owing to the simultaneous parallel operation especially when the number of active users is large.

This paper proposes an outer loop control method of fast transmit power control (TPC) for high-quality data transmission such as that with the average bit error rate (BER) of 10-6 in serial concatenated channel coding combining convolutional (inner) and Reed-Solomon (outer) codings for DS-CDMA mobile radio. In the proposed method, the outer loop control is performed based on the measured intermediate block error rate (BLER) value after inner-channel decoding. Since the number of block errors after inner-channel decoding is much greater than that of the final output after outer channel decoding, fast tracking performance of the sudden changes in the propagation conditions such as the number of multipaths and fading Doppler frequency, i.e., moving speed of the mobile station, is achieved. The experimental results clarify that the measured BLER after outer channel decoding is accurately controlled to almost a constant value from the low to high fading maximum Doppler frequency of up to 480 Hz, and that the measured BER after outer channel decoding is within the range of one-order of magnitude of the antenna diversity reception (meanwhile, the target SIR value after Rake combining varied with the range of 2.5 dB).

This paper presents a generation method of orthogonal spreading codes with different spreading factors (SFs), which are called orthogonal multi-SF spreading codes in this paper, for DS-CDMA mobile radio. The generated orthogonal multi-SF spreading codes have a tree structure and the codes are applied to the forward link such that all users, who transmit data at different rates, are orthogonalized. A group spreading modulator that simplifies the base station transmitter structure is also described. The transmission performance of the orthogonal multi-SF forward link under multi-user and frequency selective Rayleigh fading environments is evaluated by computer simulation to show that its performance is identical to that achieved by using multiple orthogonal spreading codes in parallel (orthogonal multicode forward link). Unlike the orthogonal multicode forward link, only a single Rake combiner is required at a mobile receiver which significantly simplifies the mobile receiver structure.

This paper experimentally demonstrates the possibility of 2-Mbps data transmission using a 5-MHz bandwidth (chip rate of 4.096 Mcps) wideband DS-CDMA (W-CDMA) mobile radio link in frequency-selective multipath fading environments. To reduce the mobile station transceiver complexity, three-orthogonal code multiplexing with the spreading factor (SF) of 4 is employed. In such a small SF transmission, the increased multipath interference (MPI) significantly degrades the transmission performance. We consider two-branch antenna diversity reception and fast transmit power control (TPC) as well as channel coding to mitigate the influence of MPI. Laboratory experimental results show that the use of antenna diversity reception is significant and that the fast TPC improves the transmission performance. Furthermore, the impact of the fading maximum Doppler frequency, fD, and that of the channel coding interleaving size, Tint, on the achievable BER performance are also investigated.

In DS-CDMA (including W-CDMA), a received signal can be resolved into multiple paths to be Rake combined. An important design problem of the Rake receiver is how to accurately search the paths with a sufficiently large signal-to-interference plus background noise power ratio (SIR). This paper investigates the performance of a coherent Rake receiver using pilot symbol-assisted channel estimation with fast transmit power control, and thereby optimizes three key parameters: the total averaging period, Tavg, consisting of a combination of coherent summation and power summation; each period of the summations for measuring the average power delay profile; and path-selection threshold M from the generated power delay profile. We used a path search algorithm, which searches the paths that have M times greater average signal power than the interference plus background noise power measured in the average power delay profile generated using time-multiplexed pilot symbols. It was clarified by both simulation and laboratory experiments that when M = 4, Tavg = 50-100 msec, and the number of slots for coherent accumulation R = 2, the required average transmit Eb/N0 for obtaining the average BER of 10-3 is almost minimized with and without antenna diversity for both ITU-R Vehicular-B and average equal power L-path delay profile model, in which each path suffered independent Rayleigh fading. The paper also shows that based on the field experiments, the path search algorithm with optimized path-selection parameters is robust against actual dynamic changes in the power delay profile shape.