A novel 1470-nm-band (S+ band) wavelength-division multiplexing (WDM) transmission system is described. The first advantage of S+-band transmission is suppression of degradation caused by four-wave mixing (FWM), which has been the dominant impairment factor in WDM transmission systems on dispersion-shifted fibers (DSFs). FWM suppression by using the S+ band instead of the conventional 1550-nm-band (M band) is successfully demonstrated. The second advantage is expansion of the usable bandwidth by using the S+ band together with other wavelength bands. A triple-wavelength-band WDM repeaterless transmission experiment using the S+ band, the M band and the L band (1580-nm-band) is conducted over DSF, and it is shown that degradation due to inter-wavelength-band nonlinear interactions is negligible in the transmission. Moreover, the transmission performance of an S+-band linear repeating system is estimated by computer simulation, and compared with that of other wavelength-band systems. In the experiments, thulium-doped fiber amplifiers (TDFAs) are used for amplification of signals in the S+ band.

A novel 1470-nm-band (S+ band) wavelength-division multiplexing (WDM) transmission system is described. The first advantage of S+-band transmission is suppression of degradation caused by four-wave mixing (FWM), which has been the dominant impairment factor in WDM transmission systems on dispersion-shifted fibers (DSFs). FWM suppression by using the S+ band instead of the conventional 1550-nm-band (M band) is successfully demonstrated. The second advantage is expansion of the usable bandwidth by using the S+ band together with other wavelength bands. A triple-wavelength-band WDM repeaterless transmission experiment using the S+ band, the M band and the L band (1580-nm-band) is conducted over DSF, and it is shown that degradation due to inter-wavelength-band nonlinear interactions is negligible in the transmission. Moreover, the transmission performance of an S+-band linear repeating system is estimated by computer simulation, and compared with that of other wavelength-band systems. In the experiments, thulium-doped fiber amplifiers (TDFAs) are used for amplification of signals in the S+ band.

We present a full description of a polarization-independent athermal differential quadrature phase shift keying (DQPSK) demodulator that employs silica-based planar lightwave circuit (PLC) technology. Silica-based PLC DQPSK demodulator has good characteristics including low polarization dependence, mass producibility, etc. However delay line interferometer (DLI) of demodulator had the large temperature dependence of its optical characteristics, so it required large power consumption to stabilize the chip temperature by the thermo-electric cooler (TEC). We previously made a quick report about an athermal DLI to reduce a power consumption by removing the TEC. In this paper, we focus on the details of the design and the fabrication method we used to achieve the athermal characteristics, and we describe the thermal stability of the signal demodulation and the reliability of our demodulator. We described two athermalization methods; the athermalization of the transmission spectrum and the athermalization of the polarization property. These methods were successfully demonstrated with keeping a high extinction ratio and a small footprint by introducing a novel interwoven DLI configuration. This configuration can also limit the degradation of the polarization dependent phase shift (PDf) to less than 1/10 that with the conventional configuration when the phase shifters on the waveguide are driven. We used our demodulator and examined its demodulation performance for a 43 Gbit/s DQPSK signal. We also verified its long-term reliability and thermal stability against the rapid temperature change. As a result, we confirmed that our athermal demodulator performed sufficiently well for use in DQPSK systems.