A simple method of evaluating diversity effects in the design of land mobile radio systems is introduced, and power reduction and spectrum utilization are discussed. First the processes for determining transmitter power and frequency reuse distance, which are very important factors in system design, are derived. In this derivation, the probability of a fade below a given threshold level and the probability of co-channel interference are calculated for systems operating in Rayleigh fading and lognormal shadowing environments. The probabilities are presented by simple form applicable to system design. Then, based on the derivation, a method of evaluating diversity effects is shown by taking the case of selection diversity. The results show how these effects can be taken into account in system design.

This paper is concerned with Wiener-Hopf solutions to the electromagnetic wave scattering by a conducting finite thin plate when the incident wave is not a plane wave. The incident wave is approximated in terms of a piece-wise plane wave on a divided small section of the conducting plate. The final expressions are given in an analytically compact form and the results are accurate as long as the plate width is greater than the wavelength and the divided section is so small that we can expand the incident wave by a piece-wise plane wave. A criterion for the ray tracing method is also proposed.

This paper proposes an iterative peak power reduction method with adaptive intermediary over-sampling which uses the necessary minimum bandwidth according to iteration number for wireless OFDMA systems. The required bandwidth to each iteration number is evaluated by computer simulation, and over-sampling numbers in iterative processing are controlled by using the simulation results. The results show that the required bandwidth is 1.6, 2.0, and 2.7 times of the used signal bandwidth at the iteration number of 1, 2, and 3, respectively. The proposed adaptive over-sampling method can reduce its multiplication number by 13%.

Multi-path propagation structure in the urban mobile communication environment of 25 GHz band has been measured by means of newly developed "multi-path propagation parameter measurement equipment," which is capable of estimating coupled DOA (Direction Of Arrival), TOA (Time Of Arrival) and relative field strength by super resolution techniques. Before measurement, basic performance of the equipment has been evaluated in the anechoic chamber in order to ascertain limitation on measurement. For practice and verification of outdoor propagation characteristics, basic data have been collected in a works where accurate buildings and road layout is known. Sub-sequently, data have been collected in the urban mobile communication environment and following characteristics have been confirmed. 1) DOA and TOA of wave reflected by the side of building almost follow the ray-trace. 2) Street trees make 25 GHz band wave attenuate. 3) There are such unusual cases that it is possible to communicate in spite of out of line-of-sight by multi-path propagation. 4) Narrow streets have very complicated propagation structures. Finally, technologies that should be developed for the high-speed digital mobile communication are proposed based on the measurement results.

The large PAPR of orthogonal frequency division multiplexing (OFDM) transmission is one of the serious problems for mobile communications that require severe power saving. Iterative clipping and filtering is an effective method for the PAPR reduction of OFDM signals. This paper evaluates PAPR reduction effect with a graded band-limiting filter in the iterative clipping and filtering method. The evaluation result by computer simulation shows that the excellent peak reduction effect can be obtained in the fewer iteration numbers by using a roll-off filter instead of the conventional rectangular filter, and the iteration number with the roll-off filter achieving the same PAPR is fewer by twice. The result confirms that the clipping and filtering method by using a graded band-limiting filter can achieve low peak OFDM transmission with less computational complexity.

Research and standardization activities on FPLMTS are under way throughout the world. This paper shows recent study results on radio transmission technologies in ARIB (Association of Radio Industries and Businesses), which in the standardization organization in Japan. On-going study shows two TDMA based and four CDMA based radio transmission technologies under study. These technologies need to be further studied in detail. The proposal from ARIB is expected to be summarized around the end of the year 1996.

Future broadband mobile communication systems are necessary to achieve the bit rates of 100 Mbit/s. Orthogonal Frequency Division Multiplexing (OFDM) transmission is an attractive technology because it can remove the influence of frequency selective fading in broadband transmission by adding a suitable guard interval to each OFDM symbol. However, peak-to-average power ratio (PAPR) is very large in OFDM transmission. In this paper, we propose a new PAPR reduction method which can be applied even when unusable bands are inside the system band. In the proposed method, peak reduction signals are generated by iterative signal processing only in the usable frequency band, and filtering to remove out-of-band components of the peak reduction signals is incorporated into the iterative signal processing. The results of computer simulation show that the proposed method can effectively reduce peak power without expanding the spectrum both outside the system band and into unusable bands inside the system band. By using the proposed method, the broadband mobile communication system with low peak power and high flexibility of frequency band use can be realized.

Envelope fading, random FM, and time delay spread are the major degradation factors in digital FM land mobile radio transmission systems using VHF/UHF frequencies. Taking these factors into account, the bit-error-rate (BER) performance of minimum-shift-keying (MSK) with differential detection is theoretically analyzed by using a two-path Rayleigh fading model. The postdetection selection diversity is considered in the analysis to clarify improvement in BER performance. Based on the results, it is shown that a preferable transmission rate exists for a typical land mobile propagation environment.

Field experiments have been performed in the Tokyo metropolitan area, using a 128 kbit/s GMSK signaling. Through the experiments, the diversity improvement on high-speed digital transmission performance have been made clear in land mobile radio channels.

This paper presents almost rigorous Wiener-Hopf solutions to the plane wave scattering by a conducting finite thin plate. The final field expressions are given in an analytically compact form and the results are accurate as long as the plate width is greater than the wavelength. Numerical examples are given for the near and far field distributions. A criterion is also proposed to estimate under what condition the ray tracing method holds.

One of the key technologies to realize future broadband mobile communications is orthogonal frequency division multiplexing (OFDM) transmission. However, the peak-to-average power ratio (PAPR) in OFDM transmission is so much larger than that in single carrier transmission that its adoption in mobile communication systems is uncertain. This paper evaluates the transmission performance possible with iterative peak reduction to design more efficient OFDM transmitters. The PAPR reduction effect and bit error rate (BER) performance are clarified by computer simulations. We calculate the set PAPR value that achieves a target PAPR in the iterative peak reduction method. The required Eb/N0 performance is evaluated under the calculated PAPR condition. The results are effective in designing the back-off value of a transmission power amplifier given fixed transmission quality and computational complexity.