RISC-V is a RISC based open and loyalty free instruction set architecture which has been developed since 2010, and can be used for cost-effective soft processors on FPGAs. The basic 32-bit integer instruction set in RISC-V is defined as RV32I, which is sufficient to support the operating system environment and suits for embedded systems. In this paper, we propose an optimized RV32I soft processor named RVCoreP adopting five-stage pipelining. Three effective methods are applied to the processor to improve the operating frequency. These methods are instruction fetch unit optimization, ALU optimization, and data memory optimization. We implement RVCoreP in Verilog HDL and verify the behavior using Verilog simulation and an actual Xilinx Atrix-7 FPGA board. We evaluate IPC (instructions per cycle), operating frequency, hardware resource utilization, and processor performance. From the evaluation results, we show that RVCoreP achieves 30.0% performance improvement compared with VexRiscv, which is a high-performance and open source RV32I processor selected from some related works.

For the increasing demands of computation, heterogeneous multicore architecture is believed to be a promising solution to fulfill the edge computational requirement. In FPGAs, the heterogeneous multicore is realized as multiple soft processor cores with custom processing elements. Since FPGA is a resource-constrained device, sharing the hardware resources among the soft processor cores can be advantageous. A few research works have focused on the resource sharing between soft processors, but they do not study how much FPGA logic is minimized for a different pipeline processor. This paper proposes the microarchitecture of four, and five stage pipeline processors that enables the sharing of functional units for execution among the multiple cores as well as sharing the BRAM ports. We then investigate the performance and hardware resource utilization for a four-core processor. We find that sharing different functional units can save the LUT usage to 31.7% and DSP usage to 75%. We analyze the performance impact of sharing from the simulation of the Embench benchmark program. Our simulation results indicate that for some cases the sharing improves the performance and for other configurations worst-case performance drop is 16.7%.