The characteristics of various techniques, including some new techniques, in mitigating wavelength contention in optical path setups were compared by simulations. The assumed network here is a WDM photonic network in which each node is equipped with a limited number of wavelength-tunable optical transceivers. In the photonic network, the frequency of optical path setups and releases is very high, because optical path lifetime is short and optical transceivers are time-shared, and therefore, the wavelength contention becomes a serious problem. In this paper, we propose four new techniques to mitigate the phenomenon. In those techniques, a new small-sized parameter, the history number, was introduced based on the conceptual requirements of the assumed network, namely, low-cost and low additional control load. The four proposed techniques are history recording (HR), history notifying (HN), conditional random selection (CRS), and HN with dithering target (HNDT). We have evaluated the characteristics of those techniques along with those of two conventional techniques: no mitigation and random selection (RS). The simulations were carried out while varying four parameters: the maximum generation number, the optical path lifetime, the number of wavelengths, and the number of optical transceivers per node. Consequently, it is clarified that for a sufficient number of wavelengths, namely, almost no limitation on number of wavelengths, the CRS technique is advantageous, and for a small number of wavelengths the HNDT technique is advantageous.

In this paper, a low-cost radio-on-fiber (ROF) system for a 36 GHz band road-vehicle communication system (RVCS) is proposed and demonstrated. Optical components for 10 Gb/s baseband transmission systems, which are becoming lower in cost, are used for the proposed system. The signal is transmitted in the optical link in the form of an intermediate frequency (IF) signal of the 5.8 GHz band. The third subharmonic of a local oscillator wave (LO) is transmitted simultaneously with the IF signal from the central station to the remote stations (RSs). This scheme enables the realization of RSs without costly millimeter-wave synthesizers. In such a configuration, the influence of intermodulation distortion between the IF signal and the LO subharmonic and degradation of the carrier-to-noise ratio (CNR) could possibly be a problem, and so an analysis and experiments were carried. It was clarified that the compression of dynamic range caused by the simultaneous transmission was small. Frequency tripling of the LO degraded the CNR of the LO; however, this effect was compensated for by increasing the optical modulation index (OMI) of the LO subharmonic. Increasing the OMI of the LO subharmonic proved to have no influence on the IM3 characteristics of the RF signal analytically and experimentally. The proposed low-cost system proved to have sufficient characteristics for millimeter-wave RVCS.

When a cognitive radio system dynamically utilizes a frequency band, channel control information must be communicated over the network in order for the currently available carrier frequencies to be shared. In order to keep efficient spectrum utilization, this control information should also be dynamically transmitted through channels such as cognitive pilot channels based on the channel conditions. If transmitters dynamically select carrier frequencies, receivers must receive the control signal without knowledge of its carrier frequencies. A novel scheme called differential code parallel transmission (DCPT) enables receivers to receive low-rate information without any knowledge of the carrier frequency. The transmitter simultaneously transmits two signals whose carrier frequencies are separated by a predefined value. The absolute values of the carrier frequencies can be varied. When the receiver receives the DCPT signal, it multiplies the signal by a frequency-shifted version of itself; this yields a DC component that represents the data signal, which is then demodulated. However, the multiplication process results in the noise power being squared, necessitating high received signal power. In this paper, to realize a bandpass filter that passes only DCPT signals of unknown frequency and that suppresses noise and interference at other frequencies, a DCPT-adaptive bandpass filter (ABF) that employs an adaptive equalizer is proposed. In the training phase, the received signal is the filter input and the frequency-shifted signal is the training input. Then, the filter is trained to pass the higher-frequency signal of the two DCPT signals. The performance of DCPT-ABF is evaluated through computer simulations. We find that DCPT-ABF operates successfully even under strong interference.

A technique for suppressing the clipping noise of an analogue-to-digital converter (ADC) is proposed to realize a cognitive radio transceiver that offers high sensitivity carrier-sensing. When a large bandwidth cognitive radio transceiver performs carrier-sensing, it must receive a radio wave that includes many primary user transmissions. The radio wave may have high peak-to-average power ratio (PAPR) and clipping noise may be generated. Clipping noise becomes an obstacle to the achievement of high-sensitivity carrier-sensing. In the proposed technique, the original values of the samples clipped by an ADC are estimated by interpolation. Polynomial spline interpolation to the clipped signal is performed in the first step, and then SINC function interpolation is applied to the spline interpolated signal. The performance was evaluated using the signals with various PAPR. It has been found that suppression performance has a dependency on the number of samples clipped at once rather than on PAPR. Although there is an upper limit for the number of samples clipped at once that can be compensated with high accuracy, about 20 dB suppression of clipping noise was achieved with the medium degree of clipping.

Cognitive Radios (CRs) are expected to perform more significant role in the view of efficient utilization of the spectrum resources in the future wireless communication networks. In this paper, a cognitive radio coexisting with cellular systems is proposed. In the case that a cellular system adopts Frequency Division Duplex (FDD) as a multiplexing scheme, the proposed CR terminals communicate in local area on uplink channels of the cellular system with transmission powers that don't interfere with base stations of the cellular system. Alternatively, in the case that a cellular system adopts Time Division Duplex (TDD), the CR terminals communicate on uplink slots of the cellular system. However if mobile terminals in the cellular system are near the CR network, uplink signals from the mobile terminals may interfere with the CR communications. In order to avoid interference from the mobile terminals, the CR terminal performs carrier sense during a beginning part of uplink slot, and only when the level of detected signal is below a threshold, then the CR terminal transmits a signal during the remained period of the uplink slot. In this paper, both the single carrier CR network that uses one frequency channel of the cellular system and the multicarrier CR network that uses multiple frequency channels of the cellular system are considered. The probabilities of successful CR communications, the average throughputs of the CR communications according to the positions of the CR network, and the interference levels from cognitive radio network to base stations of the cellular system are evaluated in the computer simulation then the effectiveness of the proposed network is clarified.

When cognitive radio (CR) systems dynamically use the frequency band, a control signal is necessary to indicate which carrier frequencies are currently available in the network. In order to keep efficient spectrum utilization, this control signal also should be transmitted based on the channel conditions. If transmitters dynamically select carrier frequencies, receivers have to receive control signals without knowledge of their carrier frequencies. To enable such transmission and reception, this paper proposes a novel scheme called DCPT (Differential Code Parallel Transmission). With DCPT, receivers can receive low-rate information with no knowledge of the carrier frequencies. The transmitter transmits two signals whose carrier frequencies are spaced by a predefined value. The absolute values of the carrier frequencies can be varied. When the receiver acquires the DCPT signal, it multiplies the signal by a frequency-shifted version of the signal; this yields a DC component that represents the data signal which is then demodulated. The performance was evaluated by means of numerical analysis and computer simulation. We confirmed that DCPT operates successfully even under severe interference if its parameters are appropriately configured.

We have proposed a connection-based optical wavelength division multiplexing network architecture. For the networks such as inter-office LANs, the guarantee of the bandwidths of connection-oriented calls is necessary. Notable features of the network are that multicast can be executed without copying the same data, and that time slots are rearrangeable to increase the throughput. The topology is passive star and a network controller (NWC) is connected to manage the time slot assignment. Each station's transmitting wavelength is fixed and is different from that of other stations. Each receiver changes the receiving wavelength slot by slot. Stations reserve time slots with permission of the NWC. Once a time slot is reserved the station can use the slot in every frame until the reservation is cancelled. This feature guarantees the bandwidths of connection-oriented calls. Upon receiving a time slot request, the NWC searches for a not-in-use slot common to the source station's transmitter (Tx) and the destination station's receiver (Rx). If there is no common empty slot and both the Tx and the Rx have empty slots, the NWC rearranges the already allocated time slots to create a new common empty slot. Simulations were performed to estimate the blocking rates for various cases of call bandwidth including multi-bitrate (the case in which various bandwidth calls are generated in a network) and multicast call, the calculation load of the NWC when it assigns a time slot including rearrangement, and the success rate of rearrangement. It was found that the blocking rate with the rearrangement is greatly reduced (1/10) compared with the case without rearrangement of the same throughput when the number of slots in a frame is more than 120, the number of stations in the network is 60 and the blocking rate without the rearrangement is less than 10-2. Over 100 Gbps throughput can be achieved when the number of slots in a frame is 120-240, the number of stations is 60, the bitrate of a transmitter is 2.5Gbps and the blocking rate is about 10-2. The rearrangement is especially effective in the case of multi-bitrate in which the blocking rate can be reduced to 1/100 that of the case without rearrangement at some point. It is also shown that a slot assignment including rearrangement can be executed sufficiently quickly (5s). These results indicate that practical realization of this access control architecture is possible.