A technique for suppressing the clipping noise of an analogue-to-digital converter (ADC) is proposed to realize a cognitive radio transceiver that offers high sensitivity carrier-sensing. When a large bandwidth cognitive radio transceiver performs carrier-sensing, it must receive a radio wave that includes many primary user transmissions. The radio wave may have high peak-to-average power ratio (PAPR) and clipping noise may be generated. Clipping noise becomes an obstacle to the achievement of high-sensitivity carrier-sensing. In the proposed technique, the original values of the samples clipped by an ADC are estimated by interpolation. Polynomial spline interpolation to the clipped signal is performed in the first step, and then SINC function interpolation is applied to the spline interpolated signal. The performance was evaluated using the signals with various PAPR. It has been found that suppression performance has a dependency on the number of samples clipped at once rather than on PAPR. Although there is an upper limit for the number of samples clipped at once that can be compensated with high accuracy, about 20 dB suppression of clipping noise was achieved with the medium degree of clipping.

Cognitive Radios (CRs) are expected to perform more significant role in the view of efficient utilization of the spectrum resources in the future wireless communication networks. In this paper, a cognitive radio coexisting with cellular systems is proposed. In the case that a cellular system adopts Frequency Division Duplex (FDD) as a multiplexing scheme, the proposed CR terminals communicate in local area on uplink channels of the cellular system with transmission powers that don't interfere with base stations of the cellular system. Alternatively, in the case that a cellular system adopts Time Division Duplex (TDD), the CR terminals communicate on uplink slots of the cellular system. However if mobile terminals in the cellular system are near the CR network, uplink signals from the mobile terminals may interfere with the CR communications. In order to avoid interference from the mobile terminals, the CR terminal performs carrier sense during a beginning part of uplink slot, and only when the level of detected signal is below a threshold, then the CR terminal transmits a signal during the remained period of the uplink slot. In this paper, both the single carrier CR network that uses one frequency channel of the cellular system and the multicarrier CR network that uses multiple frequency channels of the cellular system are considered. The probabilities of successful CR communications, the average throughputs of the CR communications according to the positions of the CR network, and the interference levels from cognitive radio network to base stations of the cellular system are evaluated in the computer simulation then the effectiveness of the proposed network is clarified.