A novel type Brillouin optical time-domain analysis (BOTDA), called double-pulse BOTDA (DP-BOTDA), is proposed for measuring distributed strain and temperature in a fiber with a centimeter spatial resolution. The DP-BOTDA system transmits a double-pulsed light instead of a conventional single-pulsed light into a fiber to interact with a counter-propagating continuous-wave light through the induced acoustic wave in the fiber. The interference between acoustic waves induced by the front and rear pulses of the double-pulsed light produces broad but oscillatory Brillouin gain spectra that make it possible to measure the Brillouin frequency shift accurately despite the very narrow pulse width. Our numerical simulation, which includes an estimation of the signal-to-noise ratio of the system, shows that it is possible to measure the distributed Brillouin frequency shift with a spatial resolution of 4 cm and accuracies of 1-2 MHz for a 5-km long fiber.

A novel technique is proposed for measuring the distributed strain and temperature in a fiber with a very high resolution. This technique makes use of the jagged appearance of Rayleigh backscatter traces from a single-mode fiber measured by using a coherent OTDR with a precisely frequency-controlled light source. Our preliminary experiment indicated the possibility of measuring temperature with a resolution of better than 0.01 and a spatial resolution of one meter. This temperature resolution is two orders of magnitude better than that provided by Brillouin-based distributed sensors.

We report on Brillouin optical-fiber time domain reflectometry (BOTDR) for distributed temperature or strain measurement along a single-mode optical fiber. BOTDR uses Brillouin scattering in optical fibers, whose Brillouin frequency shift increases in proportion to temperature or strain induced in the fiber. This method requires access to only one end of a fiber, as with conventional optical time domain reflectometry (OTDR) which uses Rayleigh scattering in optical fibers. In BOTDR, a coherent optical detection method is used as a backscattered light detection technique. This technique can achieve both high sensitivity and high frequency resolution and easily separate a weak Brillouin line from a strong Rayleigh scattering peak and Fresnel reflected light. Experimental results show the potential for measuring temperature and strain distribution with respective accuracies of 3 or 0.006%, and a spatial resolution of 100m in an 11.57km long fiber.

This paper proposes a surveillance system concept, which includes the analysis of fiber fault factors and monitored items, the architecture for diagnosing fiber degradation and the system configuration. Fiber faults are classified into two types. One is fiber failure caused by fiber axial tensile strain and the other is fiber loss increase caused by fiber bending and the absorption of hydrogen molecules. It was found that there is an urgent need for fiber axial strain monitoring, sensitive loss monitoring operating at longer wavelengths and water sensing, in order to detect the origin and early indications of these faults before the service is affected. Moreover, an algorithm for predicting and diagnosing fiber faults based on the detected results was investigated and systematized.

Microwave/millimeter-wave phase and amplitude characteristics of the optically controlled phased array antenna with a different SMF for each antenna feed were measured. Suitable phases for the beam steering can be realized by the adjustment of the LD wavelength independently with multiple SMFs. In addition to the phase, amplitude of each antenna feed can be controlled stably using LD current without phase variation. Furthermore, effectiveness of the calibration method of the phased array using multiple SMFs by LD wavelength adjustment is experimentally verified. Excellent microwave/millimeter-wave phase characteristics using 2- and 3-element optically controlled phased array feed were experimentally demonstrated with calibration of the phases. Phase characteristics of the array using multiple SMFs were also compared with that using a single SMF experimentally.

This letter presents the first experimental results that confirm the restorability of Rayleigh backscatter traces from a single-mode fiber measured by using a coherent optical time domain reflectometer (OTDR) with a precisely frequency-controlled light source. Based on this restorability, we can measure the distributed strain and temperature along the fiber with a very high measurand resolution that is one to two orders of magnitude better than that provided by Brillouin-based techniques for a long length of fiber.