This paper presents a new sort of multilayer piezoelectric ceramic transformer for switching regulated power supplies. This piezoelectric transformer operates in the second thickness extensional vibration mode. Its resonant frequency is higher than 1 MHz. First, numerical simulation was implemented using a distributed constant electromechanical equivalent circuit method. It was calculated that this piezoelectric transformer, which has higher than 200 mechanical quality factor Qm, could work with higher than 90% efficiency and in more than 20-W/cm3 high power density. Second, a trially fabricated transformer, which is 15 mm long, 15 mm wide and 2.2 mm thick, was examined. Modified PbTiO3 family ceramics were used for the piezoelectric transformer material, because of the large anisotropy between electromechanical coupling factors kt and kp. Obtained results indicate that the piezoelectric transformer has good resonant characteristics, with little spurious vibration, and exhibits 16-W/cm3 power density with high efficiency at 2 MHz. Moreover, a switching regulated power supply, applying the piezoelectric ceramic transformer, was built and examined.

Steady-state characteristics of the push-pull inverter with a piezoelectric transformer are analyzed. The piezoelectric transformer operating in the 3rd-order longitudinal vibration mode is used in place of a conventional magnetic transformer to produce a high output voltage to light up a cold cathode fluorescent lamp. The circuit operation, the load characteristics, the efficiency and the ZVS conditions are analyzed using equivalent circuits. These analytical results are confirmed by experiments. An example of the output current control is also shown.

A power converter with a new piezoelectric transformer is presented. The piezoelectric transformer, made of lead titanate solid solution ceramic, is operated with a thickness extensional vibration mode. This transformer can operate at high frequency, over several megahertz, with about 90% high efficiency. The resonant frequency for the transformer is 2 MHz. The power converter with the transformer applies the theory for a class-E switching converter using an electromagnetic transformer. Maximum output power was obtained when the switching frequency was slightly higher than the resonant frequency. 4.4 W output power was successfully obtained with 52% efficiency at 2.1 MHz switching frequency.

Low-profile inverter power supplies are increasingly required for backlight systems of liquid crystal displays (LCDs). A great deal of attention has been focused on the application of piezoelectric transformers (PTs) to such power supplies. To miniaturize PT inverters still further, PTs need to have sufficient high voltage-step-up-ratio, which can be achieved by a multilayered PT. First, this paper describes a method for simulating such performance using a distributed constant equivalent circuit model. The results of the simulation for a multilayered PT operated in the third order longitudinal vibration mode show that the resistance of internal electrodes causes the dominant loss factor. Next, a power inverter incorporating the multilayered PT was fabricated. This power inverter can be operated over a wide input DC voltage range from 7-20 V. Regarding a conventional inverter drive circuit, when input DC voltage range was extended, the inverter efficiency remarkably decreased. For the reason, we developed a new inverter circuit, which is equipped with an automatic drive voltage control circuit to maintain the drive voltage to the PT at a constant value. As a result, the fabricated power inverter exhibited more than 90% overall efficiency and 3.5 W output power, which is enough to light up a 12.1-inch color LCD. The maximum luminance efficiency on a light transmission plate of the backlight was as high as 30 cd/m2/W.