This paper presents the beam forming characteristics of an optical waveguide-type phased array antenna. Four linearly arranged array antenna was monolithically fabricated on one LiNbO3 substrate containing variable power dividers (VPDs) and optical phase shifters (OPSs). The amplitude and the phase of each antenna element was controlled by applying DC voltage on each VPD and OPS. Open ends of Ti-indiffused waveguides were used as antenna elements. This antenna was designed to operate at 1.3 µm wavelength band. Experimental results confirm the good beam forming capability of optical phased array antennas.

This paper theoretically and experimentally investigates the mutual coupling between two ports of dual slot-coupled circular microstrip antennas. Presented are the effects of feed configuration, slot length, slot offset from the circular disk center, circular disk radius and the dielectric constant of the feed substrate on the mutual coupling. Based on these results, the antenna with low mutual coupling was designed. The mutual coupling of under -35dB at the resonant frequency was obtained.

This paper proposes a new type of optically controlled BFN (beam forming network), an electro-optic BFN using an optical waveguide structure. In this BFN, antenna beam forming is performed using conventional optical variable phase shifters and conventional optical variable directional couplers. An electro-optic BFN can easily utilize monolithic integration capability that will be advantageous to microwave stabilization. In order to discuss practical applicability, microwave characteristics and beam forming characteristics were examined using an experimental BFN fabricated on a LiNbO3 substrate. Resulting from electro-optic lightwave control, linear phase shifting and variable amplitude distribution were measured at various microwave frequencies. Without any other control except for optical offset frequency locking and applying constant voltages, typical short term fluctuation in L-band microwave was measured to be within 3 degreesp-p in phase and 2.5 dBp-p in amplitude, respectively. For the first time, an electro-optic BFN was successful in performing beam forming in an L-band array antenna as well as coaxial cables. It was also verified that radiation pattern measured in 60 degree beam steering using the experimental BFN was comparable to that calculated using conventional microwave BFNs. The experimental results show the feasibility of utilizing an electro-optic BFN in future advanced microwave/millimeter-wave array antenna systems.

This paper presents a novel four-sector shaped-beam antenna suitable for base station antennas in 60-GHz wireless local area networks (LANs). The antenna has a plateau configuration, whose four side walls have four linearly arranged microstrip antennas. Each trapezoidal facet excites a shaped beam in the elevation plane in order to meet link-budget requirement between base station and remote terminal, taking account of directional patters of remote terminal antennas. Low-loss curved microstrip-line is applied to connect the three-dimensional antennas with active circuits mounted on a flat carrier plate. This antenna has been adopted as the base station antenna in 60-GHz wireless LANs. The first-stage transmission experiment confirms the usefulness of shaped-beam antennas in the 60-GHz band.