Light trail architecture is attracting attention as a new optical wavelength-division multiplexing network architecture that can be built with currently available devices and can achieve bandwidth allocation with granularity finer than a wavelength. Because a light trail is a shared medium, we need a medium access control (MAC) protocol to prevent collisions. Although MAC protocols using token passing can prevent collisions, the bandwidths of links that are located upstream of the token holding node are kept idle. We first propose a dynamic light trail splitting method for increasing throughput of a light trail by using such idle bandwidths. Our method splits a trail into upstream and downstream trails at the token holding node, and independent data transmission on the two trails are permitted. As a result, we expect that the split trail architecture will achieve higher throughput than the original non-split trail architecture. The degree of performance improvement with the split trail architecture depends on how appropriately we determine the upstream and downstream token holding times of every transmission node. Thus, we formulate a problem in which we optimize the token holding times to accommodate requested traffic volume as a linear programming problem. We then derive the throughput of the split trail architecture by solving the problem using the NUOPT solver and investigate the degree of improvement over the original architecture. In addition, we evaluate the end-to-end delay of the split trail architecture by simulation. According to numerical examples, the split trail architecture achieves 1) almost the same throughput as the original one for the worst-case traffic pattern where every transmission node sends data to the terminating node of the trail only, 2) about 1.6 times higher throughput for a uniform traffic pattern where every node pair requests the same traffic volume and an extremely unbalanced traffic pattern where only a few node pairs request huge traffic volume, 3) about 1.9 time higher throughput for the split trail architecture's good-case traffic pattern where every transmission node sends data to its adjacent downstream node only, and 4) the end-to-end delay enough to satisfy any application's QoS requirement according to ITU-T Recommendation Y.1541.

The scalability of routing protocol has been considered as a key issue in large-scaled wavelength routed networks. Hierarchical routing scales well by yielding enormous reductions in routing table length, but it also increases path length. This increased path length in wavelength-routed networks leads to increased blocking probability because longer paths tend to have less free wavelength channels. However, if the routes assigned to longer paths have greater wavelength resources, we can expect that the blocking probability will not increase. In this paper, we propose a distributed node-clustering method that maximizes the number of lightpaths between nodes. The key idea behind our method is to construct node-clusters that have much greater wavelength resources from the ingress border nodes to the egress border nodes, which increases the wavelength resources on the routes of lightpaths between nodes. We evaluate the blocking probability for lightpath requests and the maximum table length in simulation experiments. We find that the method we propose significantly reduces the table length, while the blocking probability is almost the same as that without clustering.

To improve TCP throughput even if the maximum receiving window size is small, a TCP performance enhancing proxy (PEP) using a UDP-like packet sending policy with error control has been proposed. The PEP operates on a router along a TCP connection. When the PEP receives a data packet from the source host, it transmits the packet to the destination host, copies the packet into the local buffer (PEP buffer) in case the packets need to be transmitted and sends a premature ACK acknowledging receipt of the packet to the source host. In the PEP, the number of prematurely acknowledged packets in the PEP buffer is limited to a fixed threshold (watermark) value to avoid network congestion. Although the watermark value should be adjusted to changes in the network conditions, watermark adjusting algorithms have not been investigated. In this paper, we propose a watermark adjusting algorithm the goal of which is to maximize the throughput of each connection as much as possible without excessively suppressing the throughputs of the other connections. In our proposed algorithm, a newly established connection uses the initial watermark value of zero to avoid drastic network congestion and increases the value as long as its throughput increases. In addition, when a new connection is established, every already-established connection halves its watermark value to allow the newly established connection to use some portion of the bandwidth and increases again as long as its throughput increases. We compare the proposed algorithm (CW method) with other methods: the FW method that uses a fixed large watermark value and the NP method that does not use the PEP. Numerical results with respect to throughput and fairness showed that the CW method is generally superior to the other two methods.