We propose a method of reducing laser-clipping-induced distortion in a subcarrier multiplexed (SCM) optical-cable TV system. This scheme reduces amplitude peaks of the SCM signal by controlling the phases of video carriers to prevent the clipping which occurs when these peaks fall below the threshold of a laser-diode. It is experimentally shown that using this method reduces the bit error rate in an AM-VSB / QAM hybrid optical-transmission system.

An optical receiver for hybrid SCM video distribution systems that distribute AM, QAM (quadrature amplitude modulation) and FM TV signals simultaneously is investigated. We propose a novel receiver configuration called the Frequency Division type Receiver (FDR) with consists of a photo detector, filter, and multiple preamplifiers. The receiver is compared with existing receivers in terms of optical sensitivity, distortion characteristics, and configuration simplicity. We clarify that the newly developed FDR type receiver is most suitable for hybrid SCM video distribution systems.

We propose the coherent subcarrier multiplexed (SCM) system with distributing local oscillator (LO) in local loop. The proposed system can realize multichannel transmission with one optical carrier by using the SCM technique and has no need to have LO at each station. Therefore the proposed system becomes cost-effective. The proposed SCM system uses bandpass filter to select a specific channel. We analyze CNR of the system with frequency-shift keying (FSK) in a multioctave configuration. First, the general expression of CNR is derived and is shown for the following parameters such as the number of channels, the position of station on the loop, and the number of stations on the loop. Second, optimal phase modulation (PM) index is derived, and the optimal CNR, minimum required power of lasers, and maximum number of stations that the proposed system can serve are shown by using it. Moreover CNR of the proposed system is compared with that of the system having LO at each station in local loop. It is shown that the proposed system can obtain good performance at the expense of slight increase of the output power of only two lasers at the central station. Therefore the proposed system is cost-effective and practical.