In this work, a measurement-based procedure aimed at deriving a behavioral model of Bulk Current Injection (BCI) probes clamped onto multi-wire cable bundles is proposed. The procedure utilizes the measurement data obtained by mounting the probe onto the calibration jig for model-parameters extraction, and 2D electromagnetic simulations to adapt such parameters to the specific characteristics of the cable bundle under analysis. Outcome of the analysis is a behavioral model which can be easily implemented into the SPICE environment. Without loss of generality, the proposed model is here used to predict the radio-frequency noise stressing the terminal units of a two-wire harness. Model accuracy in predicting the common and differential mode voltages induced by BCI at the line terminals is assessed by EM modeling and simulation of the involved injection setup by the commercial software CST Microwave Studio.

A simple method for diagnosing noise immunity of printed circuit boards (PCBs) by the bulk current injection (BCI) test was proposed, which can contribute to the PCB trace designs for common-mode noise. A grading index, which is defined as the ratio of the stray capacitances with and without critical IC of malfunction, was introduced to distinguish the PCB susceptible to the common-mode noise. This proposed method was validated experimentally using four PCBs with the same circuit but different trace design. It was observed that the noise immunity of PCBs had a good correlation with the values of these grading indices.