In this letter, a simple and robust synchronization algorithm for second generation terrestrial digital video broadcasting (DVB-T2) receivers is proposed. In the proposed detection scheme, the coarse symbol timing is estimated by decimating a correlation output to give a sharper peak timing detection metric. Such a design can improve the timing synchronization accuracy as well as enhance its robustness to frequency selective channels.

The second generation digital terrestrial broadcasting system (DVB-T2) is the first broadcasting system employing MISO (Multiple-Input Single-Output) algorithms. The potential MISO gain of this system has been roughly predicted through simulations and field tests. Of course, the potential MISO SFN gain (MISO-SFNG) differs according to the simulation conditions, test methods, and measurement environments. In this paper, network gains of SISO-SFN and MISO-SFN are theoretically derived. Such network gains are also analyzed with respect to the receive power imbalance and coverage distances of SISO and MISO SFN. From the analysis, it is proven that MISO-SFNG is always larger than SISO SFN gain (SISO-SFNG) in terms of the achievable SNR. Further, both MISO-SFNG and SISO-SFNG depend on the power imbalance, but the network gains are constant regardless of the modulation order. Once the field strength of the complete SFN is obtained by coverage planning tools or field measurements, the SFN service coverage can be precisely calibrated by applying the closed-form SFNG formula.

This paper proposes a sensing method for TV signals of DVB-T standard to realize effective TV White Space (TVWS) Communication. In the TVWS technology trial organized by the Infocomm Development Authority (iDA) of Singapore, with regard to the sensing level and sensing time, detecting DVB-T signal at the level of -120 dBm over an 8 MHz channel with a sensing time below 1 second is required. To fulfill such a strict sensing requirement, we propose a smart sensing method which combines feature detection and energy detection (CFED), and is also characterized by using dynamic threshold selection (DTS) based on a threshold table to improve sensing robustness to noise uncertainty. The DTS based CFED (DTS-CFED) is evaluated by computer simulations and is also implemented into a hardware sensing prototype. The results show that the DTS-CFED achieves a detection probability above 0.9 for a target false alarm probability of 0.1 for DVB-T signals at the level of -120 dBm over an 8 MHz channel with the sensing time equals to 0.1 second.

This paper presents a low-complexity multi-mode fast Fourier transform (FFT) processor for Digital Video Broadcasting-Terrestrial 2 (DVB-T2) systems. DVB-T2 operations need 1K/2K/4K/8K/16K/32K-point multiple mode FFT processors. The proposed architecture employs pipelined shared-memory architecture in which radix-2/22/23/24 FFT algorithms, multi-path delay commutator (MDC), and a novel data scaling approach are exploited. Based on this architecture, a novel low-cost data scaling unit is proposed to increase area efficiency, and an elaborate memory configuration scheme is designed to make single-port SRAM without degrading throughput rate. Also, new scheduling method of twiddle factor is proposed to reduce the area. The SQNR performance of 32K-point FFT mode is about 45.3 dB at 11-bit internal word length for 256QAM modulation. The proposed FFT processor has a lower hardware complexity and memory size compared to conventional FFT processors.

To address the low performance for channel scanning in the DVB-T system, we propose an enhanced front-end algorithm in this paper. The proposed algorithm consists of Auto Scan and Normal Scan, which is a part of the tuning algorithm for front-end (tuner) drivers in the DVB-T receiver. The key idea is that the frequency offset is saved when performing Auto Scan in order to reduce the channel change time for Normal Scan. In addition, the results of a performance evaluation demonstrate that our enhanced front-end algorithm improves the performance of channel scanning significantly, as compared to the generic front-end algorithm.

We study the quality of the terrestrial digital video broadcasting (DVB-T) transmission over the cable TV network. Generally, when terrestrial digital TV signals are distributed in the cable TV, a conversion is needed in the head-end, from DVB-T (OFDM) to DVB-C (single carrier). In order to avoid this costly conversion and to transmit DVB-T signal directly in the existent cable channel, many requirements have to be satisfied. It is known that phase noise represents the main limitation for OFDM based systems. In this contribution we demonstrate the sensitivity of the OFDM system for the phase noise effects by using a dynamic model for CATV channel. Then, we conclude by giving the specifications that a converter in the CATV network should have to still allow the functionality of the DVB-T system.