1-3hit |
Hiroyuki NAKAMURA Toshio ISHIZAKI Toshifumi NAKATANI Shigeru TSUZUKI
A new design concept for a common-mode signal suppression circuit for a balanced-type filter has been investigated. The degradation mechanism of the balance characteristics was studied. The degradation is caused by the common-mode signals combined with the differential-mode signals in the balanced terminals. The concept employed is the reduction of the common-mode signal using a common-mode signal suppression circuit, connected to the balanced terminals. A serial resonance circuit is formed, in which the common-mode signals are shorted to ground. The circuit was applied to the balanced-type Surface Acoustic Wave (SAW) filter. The improvement in balance characteristics, without increasing in the insertion loss, was confirmed by experiments for Global System Mobile (GSM) applications.
Kiyoshi ISHII Keiji KISHINE Haruhiko ICHINO
This paper describes a jitter suppression technique for a clock multiplier IC that uses a phase-locked loop (PLL). It is shown that the jitter cutoff frequency of the jitter transfer function can be greatly improved by adding a surface acoustic wave (SAW) filter whose center frequency equals the input frequency. The jitter transfer function is mainly determined by the characteristics of the SAW filter. Therefore, the clock multiplier IC can be set at a high loop gain to minimize the jitter generation without increasing the jitter cutoff frequency. The use of a clock multiplier IC that was fabricated with Si bipolar technology and a SAW filter with the center frequency of 155.52 MHz and a quality (Q) factor of 1500 results in a very low jitter generation of 3.5 mUI rms and an extremely low jitter cutoff frequency of about 50 kHz when the clock multiplier converts a clock frequency of 155.52 MHz into a 2.48832-GHz signal.
Mitsutaka HIKITA Nobuhiko SHIBAGAKI Kengo ASAI Kazuyuki SAKIYAMA Atsushi SUMIOKA
Taking a 1.5-GHz SAW antenna duplexer for PDC, we have developed a new configuration for the transmitter final stage filter and a new weighting technique for the receiver top filter. These transmitter and receiver filters provide insertion losses as low as 0.8 and 1.6 dB, respectively. Combining the filters, we have developed a miniature antenna duplexer of which size is 1.40.60.2 cm3 , several-time smaller than that of a conventional dielectric-filter duplexer. It also ensures sufficient power-handing capabilities.