In this paper, a balance-unbalance conversion factor (TCTL: Transverse Conversion Transfer Loss, TCL: Transverse Conversion Loss) and a radiated emission for differential type microstrip lines with a partial unbalance on a PCB (Printed Circuit Board) are investigated. As the result, after inserting an unbalance element, it can be seen that a radiated emission increased according to the deterioration of TCL. The calculated results of the TCTL and TCL by using 4-terminal pair network chain matrix agreed with the measured results very well. In order to calculate radiated emission from the differential type microstrip lines, a common mode current on differential type microstrip lines with a partial unbalance was calculated by using 4-terminal pair network chain matrix. The calculated results of the radiated emission also agreed with the measured results.

Metallic pair lines transmitting high-frequency information signals above several tens MHz are often used without being twisted, as flat floor cable installed in buildings, ribbon-type cables installed in computer equipment, and traces in printed circuit boards. However, the conversion characteristics of untwisted unbalanced metallic pair lines connecting unbalanced circuits have not been investigated over a wide range of frequencies in the MHz region. First, we developed a method to estimate effective power conversion factors using a cascade connection of F matrices, where the unbalance in impedance and admittance of each pair line is distributed uniformly along the line. As a result some useful information was obtained about the balance-unbalance conversion characteristics of the effective power which can be used to suppress EMI phenomena in wiring, especially over several decades of high frequencies. Next, we attempted to apply the conversion characteristics of untwisted unbalanced pair lines obtained at frequencies below several MHz to techniques for searching for the return circuits of conductors installed in buildings. It was clarified experimentaly that the depth of the equivalent ground plane can be estimated by comparing the measured conversion values of TV feeder lines installed at the place being tested with reference values measured in advance on a copper plate .