In this paper, we investigate a method for clustering user equipment (UE)-specific transmission access points (APs) in downlink cell-free multiple-input multiple-output (MIMO) assuming that the APs distributed over the system coverage know only part of the instantaneous channel state information (CSI). As a beamforming (BF) method based on partial CSI, we use a layered partially non-orthogonal zero-forcing (ZF) method based on channel matrix muting, which is applicable to the case where different transmitting AP groups are selected for each UE under partial CSI conditions. We propose two AP clustering methods. Both proposed methods first tentatively determine the transmitting APs independently for each UE and then iteratively update the transmitting APs for each UE based on the estimated throughput considering the interference among the UEs. One of the two proposed methods introduces a UE cluster for each UE into the iterative updates of the transmitting APs to balance throughput performance and scalability. Computer simulations show that the proposed methods achieve higher geometric-mean and worst user throughput than those for the conventional methods.

Thanks to the development of the 6th generation mobile network that makes it possible for us to move towards an intelligent ubiquitous information society, among which some novel technologies represented by cell-free network has also attracted widespread academic attention. Cell-free network has brought distinguished gains to the network capacity with its strong ability against inter-cell interference. Unfortunately, further improvement demands more base stations (BSs) to be settled, which incurs steep cost increase. To address this issue, reconfigurable intelligent surface (RIS) with low cost and power consumption is introduced in this paper to replace some of the trivial BSs in the system, then, a RIS-aided cell-free network paradigm is formulated. Our objective is to solve the weighted sum-rate (WSR) maximization problem by jointly optimizing the beamforming design at BSs and the phase shift of RISs. Due to the non-convexity of the formulated problem, this paper investigates a joint optimizing scheme based on block coordinate descent (BCD) method. Subsequently, on account of the majority of the precious work reposed perfect channel state information (CSI) setup for the ultimate performance, this paper also extends the proposed algorithm to the case wherein CSI is imperfect by utilizing successive convex approximation (SCA). Finally, simulation results demonstrate that the proposed scheme shows great performance and robustness in perfect CSI scenario as well as the imperfect ones.